Bedienungsanleitung Trotec TCH1500E (Seite 10 von 13) (Englisch)

727798

Zoom out

Zoom in

Vorherige Seite

1/13

Nächste Seite

10 EN

convector TCH 1500 E

The device goes off or does not start at all:

• The device is not standing in an upright position, it is tilted.

The device is equipped with a sensor that switches the

device off if it is not standing in an upright position. Place

the device on its feet and make sure that it is standing in

an upright position.

The device does not run and the display shows "E1":

• The room thermostat is not active. The device is provided

with an overheating protection that switches the devices

off when a temperature of 50 °C is exceeded. If the device

recognizes that no thermal sensor is active, it switches off

for reasons of safety.

• Wait for 10minutes before restarting the device. If the

device is not starting, have the electrics checked by a

specialist company or by Trotec.

• The room thermostat might be defective. Have a defective

room thermostat replaced by a specialist electrical

company.

The device does not run and the display shows "E2":

• Short circuit in the power circuit of the room thermostat.

Pull the mains plug and check the power connection.

• Check the on-site fusing.

• Wait for 10minutes before restarting the device. If the

device is not starting, have the electrics checked by a

specialist company or by Trotec.

• The room thermostat might be defective. Have a defective

room thermostat replaced by a specialist electrical

company.

Note

Wait for at least 3 minutes after maintenance and

repair work. Only then switch the device back on.

Your device still does not operate correctly after these

checks?

Please contact the customer service. If necessary, bring the

device to an authorized specialist electrical company or to

Trotec for repair.

Maintenance

Activities required before starting maintenance

Warning of electrical voltage

Do not touch the mains plug with wet or damp hands.

• Switch the device off.

• Hold onto the mains plug while pulling the power cable out

of the mains socket.

• Allow the device to cool down completely.

Warning of electrical voltage

Tasks which require the housing to be opened

must only be carried out by authorised specialist

companies or by Trotec.

Cleaning the housing

Warning of electrical voltage

Never immerse the device in water!

Clean the housing with a soft, damp and lint-free cloth. Ensure

that no moisture enters the housing. Protect electrical

components from moisture. Do not use any aggressive cleaning

agents such as cleaning sprays, solvents, alcohol-based or

abrasive cleaners to dampen the cloth.

Wipe the housing dry after cleaning.

Technical annex

Technical data

Parameter Value

Model TCH 1500 E

Heating capacity

(depending on levels 1-10)

220–1500W

Heating capacity level 5 1000W

Setting range 5°C to 35°C

Mains connection 220 – 240V/ 50Hz

Max. power consumption 1500W

Cable length 1.5m

Dimensions

(depthx widthx height)

130x 1100x 230mm

Plug type CEE7/7

Minimum distance to walls

and other objects

A: top:

B: rear:

C: side:

D: front:

1m

Weight 6.5kg

Remote control batteries Type LR03/ AAA– 1.5V (2pcs.)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Trotec TCH1500E Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Trotec TCH1500E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info