Bedienungsanleitung Troy-Bilt 26J MiniRider - TB30R (Seite 13 von 72) (Englisch)

629213

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

13Section 3 — ASSembly & Set-Up

Install The Rear Engine Cover

 Remove the two factory installed hex screws located on

the rear engine cover mounting bracket. Retain the screws



2. Install the rear engine cover by positioning it in place as



into the slots provided, then rotate it backwards to align

the mounting holes.

Figure 3-10

3. Secure the cover with the two hex screws previously

removed. Do not to over-tighten.

Installing the Hitch Plate

 Remove the factory installed hitch plate mounting



2. Position the hitch plate, packed with the loose parts, with



two bolts and hex nuts previously removed.

Figure 3-11

Connecting the Battery Cables

CALIFORNIA PROPOSITION 65 WARNING:

Battery posts, terminals, and related accessories

contain lead and lead compounds, chemicals known

to the State of California to cause cancer and

reproductive harm. Wash hands after handling.

CAUTION: When attaching battery cables, always



followed by the NEGATIVE (Black) wire.

For shipping reasons, both battery cables on your equipment

may have been left disconnected from the terminals at the

factory. To connect the battery cables, proceed as follows:

NOTE: The positive battery terminal is marked Pos. (+). The

negative battery terminal is marked Neg. (–).

 Remove the factory installed hex bolts and sems nuts

located on the end of the wiring harness. Retain the

hardware for later instructions.

2. Remove the plastic cover, if present, from the positive

battery terminal and attach the red cable to the positive

battery terminal (+) with one of the bolts and hex nuts,

previously removed, using a / inch wrench and socket.



Figure 3-12

3. Remove the plastic cover, if present, from the negative

battery terminal and attach the black cable to the negative

battery terminal (–) with the remaining bolt and hex nut.



 Position the red rubber boot over the positive battery

terminal to help protect it from corrosion.

NOTE: If the battery is put into service after the date shown

on top/side of battery, charge the battery as instructed in



operating the tractor.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Troy-Bilt 26J MiniRider - TB30R Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info