Bedienungsanleitung Truma BM 14 (Seite 16 von 68) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch)

489383

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

Trouble-shooting list

Fault Cause Rectification

No LED illuminates after

switching on.

No operating voltage.

Device fuse or vehicle fuse

defective.

If window switch present –

window above cowl open.

–

Check 12 V battery voltage, charge battery if necessary.

Check all electrical connections and lines.

Check equipment 1.6 A fuse (see fuses) or vehicle fuse,

replace fuse if necessary.

Close window.

–

Red LED illuminates

approx. 15 sec. after

switching boiler on.

Gas cylinder empty.

Gas cylinder or quick-clo-

sure valve in the gas line is

closed.

Combustion air infeed or

exhaust gas outlet closed.

Battery voltage is too low

< 10.5 V.

–

Replace gas cylinder.

Open valves and check gas infeed.

Remove the cap from the cowl or open the deck cowl.

Check openings for soiling (slush, ice, leaves etc.) and

remove if necessary.

Charge battery!

–

After a long period of opera-

tion, boiler switches to fault

and red LED illuminates.

Overtemperature monitor

has activated.

Gas pressure regulator

iced up.

Butane content in the gas

cylinder too high.

Battery voltage is too low

< 10.5 V.

–

To unlock, switch device off, allow to cool and then switch

on again.

Use de-icing system controller (Eis-Ex).

Use propane. (At temperatures below 10 °C in particular,

butane is unsuitable for heating purposes.)

Charge battery!

–

Green and red LEDs

illuminate as soon as boiler is

switched on.

Faulty electronic system.– Please contact the Truma Service Centre.–

Electric operation:

The water does not become

warm.

Operation without water;

over-temperature fuse cuts

off the heating element.

– Switch off, wait 10 minutes, fill with water, switch on.–

Water supply

Water taking an extremely

long time to heat up.

Water container furred.– Descale water system (see maintenance).–

Water running out, cannot fill

boiler.

Safety/drain valve open.– Close safety/drain valve.–

Cannot empty boiler, even

though safety/drain valve

is open.

Water dripping from draining

connection of safety/drain

valve.

Safety/drain valve draining

connection blocked.

Venting hose is closed.

The elbow connection on

the boiler is twisted.

Water pressure too high.

–

Check opening for soiling and remove if necessary.

Check opening (see above).

Check hose for kinks and remedy.

The venting hose on the elbow connection needs

to point upwards.

Check pump pressure (max. 2.8 bar). If connected to a

central water supply (rural or urban connection), a pressure

reducer must be used, which will prevent pressures higher

than 2.8 bar entering the boiler.

–

If these measures do not remove the failure, please contact the Truma Service Centre.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Truma BM 14 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info