Bedienungsanleitung Truma Mover Caravan Mover 2 (Seite 4 von 14) (Englisch)

484678

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

Operating instructions

Always observe the operating instructions and „Safety-

related instructions“ prior to starting! The vehicle owner is

responsible for correct operation of the appliance.

Function description

Note that only single axle caravans are suitable.

The Mover is a manoeuvring system for moving a caravan

without the assistance of a towing vehicle.

It consists of two separate drive units, each of which has a

12 Volt DC motor. These units are attached to the frame of the

vehicle near the wheels and are connected by lateral bars.

Once the drive rollers have been engaged against the tyres

using the provided wheel brace, the Mover is ready for ope-

ration. The equipment is operated using the remote control

facility, which transmits radio signals to the relay controller. A

separately-installed 12 Volt lead-acid battery (or suitable lead-

gel battery) provides the relay controller with power.

For an ease of operation, as an option, a cross actuation

device is available (please ask your dealer).

Safety-related instructions

l Practice operating the Mover in an open area before using

for the first time. This to fully familiarise yourself with

the handset/mover operation.

l Always check tyres and drive rollers before using the equip-

ment; remove sharp-edged stones and the like if necessary;

replace used drive rollers.

l During operation, no persons are allowed inside the caravan.

l All persons (particularly children) must remain outside

the Mover operating area.

l The distance between the radio remote control and the

caravan must not exceed 10 m during manoeuvring!

l In the event of malfunctions pull on the handbrake.

l To prevent the caravan from tipping, direct the tow hitch

downhill when manoeuvering down a slope.

l Always first apply handbrake after manoeuvring, then

remove drive rollers from tyres and block wheels (parti-

cularly on sloping surfaces!). The Mover is not suitable for

use as a parking brake for a parked caravan.

l Ensure that remote radio control is protected from unau-

thorised access (particularly by children!).

l Never tow caravan with the drive rollers engaged, since

this can damage both the tyres and the towing vehicle.

l All wheels and tyres on the caravan must be of the same

size and design (max. tyre width 205 mm, wider tyres can

be severely damaged by the rollers).

l In order to ensure that the Mover operates correctly, the

distance between the tyres and the released drive rollers

must be 20 mm. All tyres must therefore have the same

tyre pressure as per the manufacturer’s instructions (check

at regular intervals!). Readjustment is required if tyre wear

has occurred or new tyres are fitted (see drive element

installation point 4 and following text).

l Do not use the Mover as a support when jacking up the

caravan, since this can damage the drive unit.

l Do not leave sensitive items such as cameras, personal

stereo’s ect close to the Mover control box or motor cables

in the bedding locker’s. The strong electromagnetic fields

may cause them damage.

l The empty weight of the vehicle increases by the weight of

the Movers, which reduces the payload of the vehicle.

Remote Handset

a = On/Off slide switch

I On (green LED illuminates)

£ Off (green LED goes off)

b = Caravan forwards

(both wheels rotate in

forwards direction)

c = Caravan reverse

(both wheels rotate in

reverse direction)

d = Caravan right forwards

(left wheel rotates in

forwards direction)

e = Caravan left forwards

(right wheel rotates in

forwards direction)

f = Caravan right reverse

(left wheel rotates in

reverse direction)

g = Caravan left reverse

(right wheel rotates in

reverse direction)

The remote control switches off :

• after approx. 40 seconds if no button is pressed

• after 5 minutes if one of the movement buttons is pressed

continuously.

The green LED goes off.

To reactivate the remote control, move slide switch to „Off“

and then back to „On“

I after approximately 1 second.

There is no „On/Off“ switch on the caravan to be operated.

Manoeuvring the Caravan

Please read the „Safety-related instructions” before

using the Mover!

1. With the caravan free from the tow vehicle (handbrake on),

engage the drive rollers by use of the 19 mm AF wrench

provided or the steady leg brace. The action will be quite stiff

and will snap into place. The movement required is just over

1/2 turn. Turn the wrench until it will turn no more without

excessive force. Perform at both sides of caravan.

Before operating the Mover, release the handbrake.

2. Move slide switch (a) on remote control to the „On“

I positi-

on. This switches the Mover on.

3. The six direction buttons provide movement in six directions

– forward, reverse, left forward, left reverse, right forward, right

reverse. In addition, the „left forward“ (e) and „right reverse“

(f) buttons or „right forward“ (d) and „left reverse“ (g) buttons

may be pressed at the same time to turn the caravan without

moving forward.

The Softstart makes the caravan start to move without

jolting.

4. The caravan will stop when the buttons are released or the

radio signal is too weak. Other radio transmitters and other

Mover handsets will not cause operation of your Mover.

Truma Mover Caravan Mover 2 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info