Bedienungsanleitung Truma Saphir comfort RC (Seite 17 von 74) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Schwedisch)

590218

Zoom out

Zoom in

Vorherige Seite

1/74

Nächste Seite

The time always appears on the display.

The time must be reset after changing the batteries or after a

daylight saving time change.

Timer ON / OFF

The On / Off time of the air conditioning system can be set

in advance for a minimum of 15 minutes to a maximum of

24 hours, starting from the current time, using the integrated

timer.

The device must be switched on using the remote control in

order to program it.

Set required operating mode and room temperature.

Then select TIMER ON or TIMER OFF using the “TIMER se-

lection buttons”. Set the required On / Off time using the

“Time setting” buttons (15 minutes to 24 hours) and con-

firm with TIMER ON or TIMER OFF.

Pressing the relevant timer button again deactivates the timer

function.

Reset

Resets the settings of the remote control to the factory set-

tings when pressed using a ballpoint pen, for example. Setup

symbol flashes. Remote control settings set to “Circulated air”,

fan level low, no timer set.

Resend

The previous settings are resent.

Setup

Tune the remote control to the air conditioning system that is

going to be operated. Settings set to “Circulated air”, fan level

low, no timer set.

Maintenance

There is a fluff filter (n) and a particle filter (p) on the front of

the device for cleaning the room air.

Fig. 5

The fluff filter (n) must be cleaned at regular intervals (at least

2x per annum) and changed if required (part no. 40090-64600).

We recommend replacing the particle filter (p) every year at

the beginning of the season (part no. 40090-58100).

The cold air ducts must be removed before replacing the fil-

ters. Before replacing the fluff filter (n), release the clip (k) and

the sensor (s) using a flat-bladed screwdriver. Pull the fluff

filter (n) a little way forward at the recesses at the top edge

and remove from above. Then remove particle filter (p) from

the front. Re-fit the clip and the sensor in the same position

during assembly.

Fig. 6

When installing the particle filter (p) the printed arrows

must point towards the device – they indicate the circu-

lated air flow direction. Never operate the device without

a filter. Operating the device without a filter can cause evap-

orator coil soiling, which can have a detrimental effect on the

performance of the device!

The condensation drain is under the floor of the vehicle. In

order to allow the condensation to drain away freely, check

whether the drain is free of dirt, leaves and the like at regular

intervals. Failure to do this may allow condensation to

penetrate the vehicle!

Troubleshooting

Is the motor home / caravan 230 V power supply lead prop-

erly connected, and are the fuses and circuit breakers OK?

Fault Cause / Remedy

Device not cooling – Thawing process in progress /

wait until thawing procedure is

complete.

– The temperature set on the re-

mote control has been reached /

set temperature on remote

control to less than room

temperature.

Device not heating – Thawing process in progress

(outside temperature between

4 °C – 7 °C) / adjust fan to lower

setting

– Outside temperature below 4 °C

Device providing insuf-

ficient cooling or no

cooling at all

– Filters soiled / change filters

– External air routes soiled,

blocked / clear air routes

Moisture at cold air

ducts

– High air humidity / close win-

dows and doors and select high

fan level

Remote control

not working

– Check batteries in remote

control / replace batteries if

necessary

Device not reacting

to remote control

commands

– Check whether there are ob-

structions between the remote

control and the IR receiver / re-

move obstructions if necessary

– Is the remote control tuned to

the IR receiver? / tune remote

control to IR receiver

If these actions fail to remedy the fault, please contact Truma

Service.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Truma Saphir comfort RC Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info