681450
7
Zoom out
Zoom in
Vorherige Seite
1/54
Nächste Seite
1
ALMDT-2000 INFRARED MOTION SENSOR
1. Place batteries
Open the battery slot on the back side of the motion sensor by pushing the pull-tab down and
removing the battery cover. Insert two AA 1,5V Alkaline batteries as shown above. Observe the correct
polarity of the batteries (place plus and minus on the correct side). Close the battery slot.
2. LED indicator
The sensor has a LED indicator in the detection window. The LED behaviour is as followed:
Confirm pair: LED will blink 5 times
Confirm unpair: LED will blink 5 times
Low battery: LED will blink 3x every 6 sec
3. Pairing the ALMDT to Siren
Consult the manual of the Siren to activate the learn mode. Send (while the learn mode of the Siren is
active) a connect-signal by pressing the SET button for 2 seconds with a sharp object on the back of
the sensor. The LED indicator will flash 5x to confirm that the pairing has been done successfully.
4. Mounting the ALMDT
Because the motion sensor is wireless, it can be easily placed in your house. Mount the backplate of
the motion sensor on a flat surface and secure it with screws. (Screws are included).
5. Place ALMDT on the backplate
Place the ALMDT on the backplate. Make sure that the backplate is fitted in the location of the tamper
switch. This is a switch that prevents the sensor from being removed when it is mounted. When the
sensor is removed from the backplate and the Siren is armed the tamper switch will activate the alarm
immediately.
6. Secure the ALMDT
When the ALMDT is placed on the backplate pull it down untill you hear a click to secure it and lock the
tamper switch.
Note: After arming the Siren it is possible to move in front of the sensor for 1 min. It takes ~1.5 minute
before the sensor will be completely active.
EN
7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Trust 71114 - ALMDT-2000 Wireless Motion Sensor wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info