Bedienungsanleitung TTulpe C-Meister 11 P37 Eco (Seite 8 von 24) (Englisch)

782477

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Support bracket

Having established the position of the appliance, drill no. 2 Ø 6 holes

to apply the support bracket (use the same bracket to mark the holes).

Secure it with the plugs supplied.

Below is descried the type of rear and horizontal outlet which is the

most common:

hPosition the paper template between the wall and the appliance

support ns

hMark the centre of the hole of the pipe

hDrill a Ø 105 mm hole as indicated on the paper template

hConnect the appliance to the support bracket and connect the ue

gas release tubes.

Fig. 6 - Support bracket

Electrical connection

Electrical current with 230V voltage

Before any work on the electrical equipment, always dis-

connect the 230V voltage.

Connect the supplied cable to the line respecting the phase, neutral and

earth.

In the event of replacement of the power supply cable, an operation

which must in any case be performed by a qualied technician, connect

the appliance with a cable type H 05 V VF 3 x 0.75 mm2 with Ø max 7mm

similar to that provided. In addition, the earth wire must be 30 mm longer

than the power supply cables. Power the appliance via an all-pole switch

with an opening of at least 3 mm between the contacts. For maintenance

operations, disconnect the power by turning the omni-pole switch.

N.B. no responsibility is accepted for damage to persons, animals or

property caused by failure to earth the appliance and the creation of an

electrical installation that does not comply with current standards (CEI

68.4).

Arrange for qualied personnel to check that the electrical installation is

suitable for the maximum power absorbed by the appliance, as indicated on

the data plate, ensuring in particular that the wire section of the systemis

suitable for the power absorbed by the appliance.

For the main power supply of the appliance from the mains, the use of

adapters, multiple sockets and/or extension cords is not permitted.

The use of any component that uses electricity involves the observance

of a number of fundamental rules such as:

hDo not touch the appliance with wet parts of the body and/or

bare feet

hDo not pull the electrical cables

hDo not leave the appliance exposed to atmospheric agents (rain,

sun, etc.)

hDo not allow the appliance to be used by children or inexperi-

enced persons.

The power cable of the appliance must not be replaced by the user.

If the cable becomes damaged, switch off the appliance and for the purposes

of replacement, use exclusively professionally qualied personnel.

Where the appliance will not be used for a certain period of time, it is

advisable to disconnect the power supply to all the system components

that use electricity.

Gas connection

Non-compliance with theapplicable laws may result in re or

explosions, causing serious damage to materials, animals or per-

sons, possibly even irreparable

Determine the diameter of the pipe in accordance with the regulations

in force.

Before installing the appliance blow into the gas pipe in order to remove

any residue. Connect the water heater to the gas pipe of the internal

system and t upstream from the appliance a valve for gas interception

and opening.

Comply with the prescriptions of the relevant standard.

For initial start-up of the appliance, the following checks must be carried

out by qualied technicians:

hChecking for internal and external leakage of the gas supply system

hAdjustment of the gas ow rate according to the power required

by the appliance

hThat the appliance is powered by the type of gas for which it was

designed

hThat the gas supply pressure is in the range between the values

indicated on the data plate

hThat the gas supply system is dimensioned for the capacity re-

quired by the appliance and is equipped with all the safety and

control devices required by current regulations.

hIn case of absense and if the water heater is not used for a longer

period, close the gas supply to the device.

Do not obstruct the ventilation openings of the room where a gas appliance

is installed in order to avoid dangerous situations such as the formation

of toxic and explosive mixtures.

Do not use the gas pipes as electrical appliance earthing devices.

Water connection

Water at a temperature higher than 50°C causes se-

rious burns. Check the water temperature before any

use.

Connect the water heater to the water mains and t a water shut-off valve

upstream from the appliance.

Looking at the appliance, the cold water inlet is on the right and the hot

water outlet is on the left.

Make sure that the piping of your water system is not being used as an earth

electrode for your electric or telephone system. It would be completely

unsuitable for this purpose.

Severe damage to the pipes could occur in a short space of time and to

the appliance.

The minimum distance between the water heater and tap point of hot

water must exceed of 0,5 m.

Evacuation of combustion products

The manufacturer separately supplies various types of air intake and

fume exhaust pipes specic for any installation need.

By varying the type of installation the classication of the water heater

also varies, precisely:

hB type: the terminal takes air intake directly from the room in

which the water heater has been installed.

The room must be ventilated by a suitable air intake meeting

current standards.

hC type: The water heater is a type C appliance (sealed chamber)

and must therefore have a secure connection to the ue release

tube and combustion air intake that both ow outside and without

which the appliance cannot function.

In rooms with corrosive vapour risks (for example, laundries, hair

dressers, galvanic processing rooms, etc.), it is very important to use the

177

162

150

180

TTulpe C-Meister 11 P37 Eco Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von TTulpe C-Meister 11 P37 Eco

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info