Bedienungsanleitung TTulpe Outdoor HD-6 (Seite 10 von 24) (Englisch)

782464

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

5. Faults

Portable tankless water heater will not start – there are no audible clicks at

startup:

a. The ﬁrst thing to check is to ensure that the incoming water on the “right” side of

the portable tankless water heater. If the incoming and outgoing are reversed,

the portable tankless water heater will not work. The incoming is on the far right

and the outgoing is in the middle.

b. The “On/Off” switch should be with the ”-” sign pushed down.

c. Check to make sure you have fresh batteries and they are installed in the correct

position.

d. Number one reason that the portable tankless water heater does not ignite is

that there is not enough water pressure. You need to make sure that you have a

minimum of 1.0 bar of sustained water pressure.

e. A wire has become disconnected inside the portable tankless water heater

during shipping. Make sure the gas is OFF and the switch is in the OFF position.

The front cover is held by four screws, two top, two bottom. The knobs pull off.

All the wiring is done with push together plastic connectors. They are all visible

without further dismantling of the portable tankless water heater. It should be

obvious when a wire has become disconnected.

f. It is possible that some debris or epoxy might have entered the water regulator.

Check to see if the ﬁlter screen on the water inlet is clear of debris. You can also

reverse the hook-up by taking your water source and hooking it up to the water

outlet side and back ﬂushing the system. Propane gas cylinders sometimes are

contaminated with air, especially new tanks upon their ﬁrst ﬁlling. Cycle the

portable tankless water heater on and off by using the shower head switch several

times (5) to purge the air from the gas.

g. The build in tilt switch is engaged. Make sure you mount the water heater vertical

with the black grid on top.

Portable tankless water heater will not start - but there are audible clicks at

startup:

a. The portable tankless water heater requires a minimum of about 2 litres per minute

and a minimum of about 1.0 bar. Note: water pressure is at the lower end of

operating parameters. You will need a sustained water pressure of approximately

1.8 - 4.1 bar for adequate use if you are using a 12/24 volt pump. See adjustment

in previous section.

b. High Wind. For safety reasons the heater will not start in sustained wind, ﬁnd an

alternate location for the water heater.

c. Out of, or low on gas. Propane gas cylinders sometimes are contaminated with

air, especially new tanks upon their ﬁrst ﬁlling. Cycle the portable tankless water

heater on and off by using the shower head switch several times (5) to purge the

air from the gas.

d. The ignition sensor is bent and/or too close to the burner. Look to ensure that

the ignition pins and the heat sensor are completely vertical and they do a 90

degree to the back of the box. lf they are not straight (i.e. a 45 degree angle) then

you can straighten them carefully with pliers.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

TTulpe Outdoor HD-6 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von TTulpe Outdoor HD-6

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info