Bedienungsanleitung Tunturi FitCycle 30 (Seite 17 von 48) (Deutsch, Englisch, Holländisch, Französisch)

738068

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

English

Remark: During the process of pulse measurement,

because of the contact jamming, the measurement

value may be higher than the virtual pulse rate during

the first 2~3 seconds, then will return to normal level.

The measurement value cannot be regarded as the

basis of medical treatment.

NOTE

• If the display is faint or shows no figures, please

replace the batteries.

• The monitor will automatically shut in standby

mode if there is no signal received after 4

minutes.

• The monitor will be auto-powered on when

starting to exercise or at the push of a button.

• The monitor will automatically start calculating

when you start to exercise and will stop

calculating when you stop exercising for 4

seconds.

Specifications:

Function

- Auto scan Every 4 seconds

- Time 0:00 ~ 99:59

- Current speed The maximum speed to be

displayed is 99,9 KM/H

- Trip Distance 0.00 ~ 99.99 KM

- Calories 0.0 ~ 999.9 K.Cal

- ODO 0.1 ~ 999.9 KM

- Pulse rate 40 ~ 240 BPM

Operating Temperature 0°C ~ +40°C

Storage Temperature -10°C ~ +60°C

Extra notes

- If the display is faint or shows no figures, please

replace the batteries.

- The monitor will automatically shut off if there is no

signal received after 4 minutes .

- The monitor will be auto-powered on when starting

to exercise push button w/signal in.

- The monitor will automatically start calculating

when you start to exercise and will stop calculating

when you stop exercising for 4 seconds .

Cleaning and maintenance

The equipment does not require special maintenance.

The equipment does not require recalibration when

it is assembled, used and serviced according to the

instructions.

WARNING

• Do not use solvents to clean the equipment.

• Clean the equipment with a soft, absorbent cloth

after each use.

• Regularly check that all screws and nuts

are tight.

• If necessary, lubricate the joints.

Defects and malfunctions

Despite continuous quality control, defects and

malfunctions caused by individual parts can occur in the

equipment. In most cases, it will be sufficient to replace

the defective part.

- If the equipment does not function properly,

immediately contact the dealer.

- Provide the model number and the serial number of

the equipment to the dealer. State the nature of the

problem, conditions of use and purchase date.

Transport and storage

WARNING

• Carry and move the equipment with at least two

persons.

• Remain standing in front of the equipment

on each side and take a sturdy grip at the

handlebars. Tilt the front of the equipment

so as to lift the rear of the equipment on the

wheels. Move the equipment and carefully put

the equipment down. Place the equipment on a

protective base to prevent damage to the floor

surface.

• Move the equipment carefully over uneven

surfaces. Do not move the equipment upstairs

using the wheels, but carry the equipment by the

handlebars.

• Store the equipment in a dry place with as little

temperature variation as possible.

Additional information

Packaging disposal

Government guidelines ask that we reduce the amount

of waste material disposed of in land fill sites. We

therefore ask that you dispose of all packaging waste

responsibly at public recycling centres.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tunturi FitCycle 30 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info