5.2 Unit dimensions (mm)
Observe the safety distances from the unit (calculated in mm).
5.3 Safety distances
Keep this information in mind when mounting the unit.
After unpacking, check that the delivery is complete and that all parts are free of possible
transport damage.
1. - cooker hood
2. - reducer 150 - 120 mm
3. - non-return valve
5.1 Delivery package
5. INSTALLATION
ATTENTION!
This unit is designed to be installed in a furniture cabinet.
1
See image
See images
See image
Check that the built-in furniture is positioned horizontally and that it has sufficient load-
bearing capacity.
1.
The maximum weight of the unit is 9.9 kg.
Note: Follow the manufacturer's specifications regarding the load-bearing capacity of the
built-in furniture.
2. Make sure that the built-in furniture withstands temperatures up to 90 °C.
3. Make sure that the built-in furniture allows for embedding even after the cutting work is
done.
5.4 Checking the furniture
5.5 Installation steps
Note! Do not connect the power cable until the installation is complete!
Note! When the hood and the equipment powered by energy other than electric work
simultaneously, the negative pressure in the room must not exceed (4 x 10 Bar). Get a
second person to help you with the installation.
1.Cut the installation gap in the cabinet wall under which the hood will be mounted.
Use the following dimensions (mm) as a guide. See image
-5
2. Insert the hood into the furniture body.
Make sure that the elastic clips are fixed on the furniture body on both sides.
2a 2b 2c 2d
3
4a
See image 4b
See image 4c
3. Adjust the screws 1, 2, 3, 4 until the flanges of both sides are fixed in the furniture body.
See images 4d 4e
4. Installing the grease collector:
Position the grease collector in the support, until it is fixed. See image 4f
5.6 Fitting the grease filters
ATTENTION!
By falling, the grease filter can damage the cooking zone below.
Hold the filter firmly by the two handles.
Initially insert the filter on the opposite side of the control panel, above the rear fixing
channel positioned over the grease collector. See image
1.
5a
EN
18
