Bedienungsanleitung Turbionaire Comfy (Seite 43 von 70) (Englisch)

804683

Zoom out

Zoom in

Vorherige Seite

1/70

Nächste Seite

Presence of fire extinguisher

If any hot work is to be conducted on the refrigerating equipment or any

associated parts, appropriate fire extinguishing equipment shall be available to

hand. Have a dry powder or CO2 fire extinguisher adjacent to the charging area.

No ignition sources

No person carrying out work in relation to a

refrigerating system

which

involves exposing any pipe work shall use any sources of ignition in such a

manner that it may lead to the risk of fire or

explosion. All possible ignition

sources, including cigarette smoking, should be kept sufficiently

far away

from the site of installation, repairing, removing and disposal, during which

refrigerant can possibly be released to the surrounding space. Prior to work

taking place, the area around the equipment is to be surveyed to make sure

that there are no flammable hazards or ignition

risks.

“

”

signs

shall

displayed.

Ventilated area

Ensure that the area is in the open or that it is adequately ventilated before

breaking into the system or conducting any hot work. A degree of ventilation

shall continue during the period that the work is carried out. The ventilation

should safely disperse any released refrigerant and preferably expel it

externally into the atmosphere.

Checks to the refrigerating equipment

Where electrical components are being changed, they shall be fit for the purpose

and to the correct specification. At all times the manufacturer’s maintenance and

service guidelines shall be followed. If in doubt, consult the manufacturer’s

technical department for assistance.

The following checks shall be applied to installations using flammable refrigerants:

–

the actual refrigerant charge is in accordance with the room size within

which the refrigerant containing parts are installed;

–

the ventilation machinery and outlets are operating adequately and are not obstructed;

–

if an indirect refrigerating circuit is being used, the secondary circuit shall

be checked for the presence of refrigerant;

–

marking to the equipment continues to be visible and legible. Markings

and signs that are illegible shall be corrected;

–

refrigerating pipe or components are installed in a position where they are

unlikely to be exposed to any substance which may corrode refrigerant

containing components, unless the components are constructed of materials

which are inherently resistant to being corroded or are suitably protected

against being so corroded.

Checks to electrical devices

Repair and maintenance to electrical components shall include initial safety checks

and component inspection procedures. If a fault exists that could compromise

safety, then no electrical supply shall be connected to the circuit until it is

satisfactorily dealt with. If the fault cannot be corrected immediately but it is

necessary to continue operation, an adequate temporary solution shall be used.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Turbionaire Comfy Seite 43

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info