Bedienungsanleitung Turbionaire Revigo 10 (Seite 13 von 56) (Englisch, Französisch, Italienisch)

804681

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

-When the unit operates in the cooling operation, drying operation, the ambient temperature

sensor senses the evaporator coil temperature is below -1°C, after the compressor will stop

operating for 10 minutes or the coil temperature up to 7℃, the unit restart to cool operating

mode.

-When the unit operates in the drying operation, once the coil temperature sensor senses the

temperature of the evaporator is below 40℃ and the differential temperature between coil

temperature and room temperature is below 19℃ after the compressor operation for

20minutes, the unit start defrosting for 5 minutes and the power indicator blinking. Overload

Protection - In the event of a power loss, to protect the compressor there is a 3-minute delay

until the compressor restarting.

DRAINAGE

Self- evaporating system

The self-evaporating system uses the collected water to cool the condenser coils for

better efficient performance. It is no need to empty the drainage tank in cooling

operation except in drying operation and high humidity conditions. The condensate

water evaporates at the condenser and evacuated through the exhaust hose.

For continuous operation or unattended operating in drying and heating operation,

please connect the attached drain hose to the unit. Condensate water can be

automatically flow into a bucket or drain by gravity.

-Switch off the unit before operating.

-Remove the plug of the water outlet

opening, and keep it in safe area.

-Securely and properly connect the drain

hose and make sure it is not kinked and

clear of obstruction.

-Place the outlet of hose over a drain or

bucket and ensure that water could freely

flow out of the unit.

-Do not submerge the end of hose into

water; otherwise it can cause "Air Lock" in

the hose.

Remove the rubber sealing plug

Continuous drain hose

To avoid water spillage:

•As the negative pressure of condensate drain pan is large, tilt the drain hose

downward toward the floor. It is appropriate that the degree of inclination should exceed 20

degrees.

•Straighten the hose to avoid a trap existing in the hose.

6. CLEANING AND CARE

CLEANING THE AIR FILTER (every two weeks)

Dust collects on the filter and restricts the airflow. The restricted airflow reduces the

efficiency of the system and if it becomes blocked it can cause damage to the unit.

The air filter requires regular cleaning. The air filter is removable for easy cleaning. Do not

operate the unit without an air filter, or the evaporator may be contaminated.

-Press POWER button to switch off the unit and unplug the power cord.

-Remove the filter mesh from the unit.

-Use a vacuum cleaner to suck dust from the filter.

-Turn the filter over and rinse the air filter under running water. Let the water run through

the filter in the opposite direction of air flow. Set aside and allow the filter to air dry

completely before reinstalling.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Turbionaire Revigo 10 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info