Bedienungsanleitung Tusa Buoyancy Compensator Jacket (Seite 9 von 12) (Englisch)

557352

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

BCJ ATTACHMENT

GUSSET ADJUSTER STRAP (BCJ-7000, 6910, 6900, 5960)

(Fig. 48)

(1) Put the BCJ on your back and tighten the shoulder

belts by pulling the D-shaped rings (Fig. 48) on the

front edge of the shoulder belts, tightening them

enough to fit comfortably to your body. Stoop forward a

little, as if you were carrying a child on your back, so as

to lessen the burden of the tank on your back.

(Fig. 49)

(2) Tighten the cummerbund securely and fasten with the

Hook and Loop fastener (Fig. 49).

Make sure that the hook is overlapping exactly on top

of the Loop on the cummerbund.

* If there is not exact overlap, you must adjust the

length of the waist belt (see page13).

Side gusset of bladder can

be adjusted to the proper

buoyancy by tightening

(increase) or loosing

(decrease) the gusset

adjuster strap. (Fig. 47)

WARNING :

To control your ascent when drawing your weight cartridges, release one side at a

time. Often, it may not be necessary to draw both weights to ascend safetly.

The release handles are difficult to view while diving , so it is important that you

practice and become familiar with the location and shape of the weight release

handle prior to each dive.

CAUTION :

Always notify your diving instructor or diving buddy that you are using a B.C.J. with

a Weight Loading System.

(Fig. 47)

ON DEMAND WEIGHT RELEASE PROCEDURE (BCJ-1800, 1650)

(Fig. 44)(Fig. 43)(Fig. 42)

WARNING : With the B.C.J. deflated completely, and no additional weights attached,

the amount of weight in the non-releasable weight pockets MUST not cause you to

sink from the surface of the water.

ALWAYS consult with your dive instructor on the use of the non-releasable pockets

for additional weights.

ALWAYS notify your divemaster and dive buddy on the use of your non-releasable

pockets.

1. Securely grab hold of the weight release knob as in the photograph. (Fig. 42)

2. When you pull on the knob forcefully, the Hook and Loop fastener of the cartridge

closure cover peel apart. (Fig. 43)

3. Pull on the knob further to pull out of the weight cartridge. (Fig. 44)

*“NON RELEASABLE” EXTRA POCKETS

*ADJUSTING THE ANCHOR BELT LENGTH (BCJ-9300, 5560, 1650, 3860)

(Fig. 45)

Two non-releasable not zippered pockets are located in the rear of

the B.C.J. (Fig. 45)

These pockets may be used for additional weights. However,

please note that these pockets CANNOT be reached by the diver

him/herself to release the weights. Please refer to the warning

listed below for further details.

(Fig. 46)

If you fill the cartridge up completely with weights, the

pocket of the bladder tends to hang down under the

weight. To compensate for this, tighten the strap on the

anchor belt so that you feel a little weight. (Fig. 46)

BCJ(CE)002-021 GB 10.11.17 9:35 AM ページ 16

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tusa Buoyancy Compensator Jacket Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info