Checking before use. (setting)
Please confirm that there is no debris adhering to the O-ring, O-ring groove or O-ring connecting surface.
Also confirm that there are no scratches and that an appropriate amount of silicon grease has been used.
Check the switch of "Battery Selection Switch" to
LEAD-ACID battery.
Place the battery housing (head Assy) carefully in
position taking note that the ribs on the underneath
of the SAV-7 match up.
Do not set wrong side!
WARNING
After setting the housing, confirm that there is a uniform space of
about 0.5mm between the battery housing (head Assy) and the motor
housing (body Assy).
If the space is less than 0.5mm or if the two parts are joined, there is the
possibility of the O-ring coming out of the O-ring groove.
Confirm that this not the case before proceeding.
Please confirm that all four locking buckles are securely locked.
STEP4 Checking the locking buckle.
Put the weight plate under the battery, if it is not
necessary to float the SAV-7.
WARNING
Please only use a fully charged battery otherwise damage will be caused. Also check again that the correct
charger was used with the correct battery.
Set the battery so that the connectors on the body and the battery line up.
At this time, confirm that the warning lamp isn't on.
Please do not use the scooter if the warning lamp is on as this may indicate a water
leak has occurred
Next, the battery socket is connected with the body plug.
(Please always remove the connector when not in use or during travel to your destination)
Connect the socket to right way.
Please set the fully charged
battery in the body housing in
the correct position.
LOCK
LOCK
LOCK
LOCK
Check no gap after setting
09
The SAV-7 is able to float without weight
plate.
STEP1 Set the battery.
STEP2 Set the battery housing (head Assy).
STEP3 Checking the housing seal.
0.5mm
Water Leak Alert Lamp
PATENTED
Battery Selection Switch
Battery Selection Switch
Preparation
NI-MH
LEAD-ACID
