13665
11
Zoom out
Zoom in
Vorherige Seite
1/34
Nächste Seite
11
CONDITIONS FOR USE
- This electrical domestic appliance must be connected to a mains supply of 220/240 V, 50 Hz, through a socket
with an earth connection.
- Protected with a slow acting 10 A fuse.
- Should it be necessary to use an extension lead, this will have to a minimum wire gauge of 1.5 mm
2
per terminal,
be provided with an earth wire, and be no longer than 25 m.
- There is a compartment at the rear of the appliance used for storing the mains cable.
- Do not let water get inside the appliance.
- Do not cover the air intakes or outlets on your appliance.
- If the mains cable is damaged it must be replaced. To do this, get in touch with the manufacturer, after-sales
service dept. or someone similarly qualified.
Attention!Attention!
Attention!Attention!
Attention!
This apppliance is not suitable for dehumidification at ambient temperatures of below 18This apppliance is not suitable for dehumidification at ambient temperatures of below 18
This apppliance is not suitable for dehumidification at ambient temperatures of below 18This apppliance is not suitable for dehumidification at ambient temperatures of below 18
This apppliance is not suitable for dehumidification at ambient temperatures of below 18
°
C.C.
C.C.
C.
After turning your appliance off, wait at least 3 minutes before turning it back on again. The cold circuit needs thisAfter turning your appliance off, wait at least 3 minutes before turning it back on again. The cold circuit needs this
After turning your appliance off, wait at least 3 minutes before turning it back on again. The cold circuit needs thisAfter turning your appliance off, wait at least 3 minutes before turning it back on again. The cold circuit needs this
After turning your appliance off, wait at least 3 minutes before turning it back on again. The cold circuit needs this
amount of time in order to reset.amount of time in order to reset.
amount of time in order to reset.amount of time in order to reset.
amount of time in order to reset.
MOBILITY
The appliance is fitted with wheels which allow it to be moved about. Should it be necessary to tilt the appliance
when moving it, the internal water tank will have to be emptied beforehand with the help of the drain pipe (fig.A,3)
placed onto the drain cock (fig.A,7) at the bottom of the appliance, as shown in (fig K). Once the appliance has
been put back into the upright position leave it to stand for a few minutes before switching it back on.
Attention!Attention!
Attention!Attention!
Attention!
Take special care when moving this appliance. The base is fitted with a drain outlet pipe that may break off ifTake special care when moving this appliance. The base is fitted with a drain outlet pipe that may break off if
Take special care when moving this appliance. The base is fitted with a drain outlet pipe that may break off ifTake special care when moving this appliance. The base is fitted with a drain outlet pipe that may break off if
Take special care when moving this appliance. The base is fitted with a drain outlet pipe that may break off if
knocked.knocked.
knocked.knocked.
knocked.
INSTRUCTIONS FOR USE
INSTALLATION
A) Hinge or sash windows (fig. L)
- Connect the diffuser sleeve to the warm air expulsion pipe.
- Open the window slightly and place the sleeve between the jamb and the frame.
- Close the window as far as possible and hold it with the suction cup supplied.
B) Sliding windows (fig. M)
- Connect the diffuser sleeve to the warm air expulsion pipe.
- Fit the sliding window installation accessory using the side of the window frame to support it and then
adjust it to the right height.
- Close the window as far as possible and insert the diffuser sleeve through the outlet hole.
C) Fixed installation
- Use the optional window/wall sleeving accessory which can be purchased from your usual supplier of
electrical appliances. (Ref.: B1RKZ06009)
- It will be necessary to make a hole in the wall to accommodate the hot air pipe sleeve (Fig. I).
- Take the diffuser sleeve off and connect the warm air expulsion pipe to the accessory.
AA4000/4020/8000 13/9/04, 10:2611
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Ufesa AA4020 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info