464825
17
Zoom out
Zoom in
Vorherige Seite
1/23
Nächste Seite
- 15 -
Preparatory steps
1. Push the lifting levers
q
into each other.
Turn them until they are secured against being
pulled apart.
2. Place the lifting levers
q
onto the release valve
r
at the front.Turn it clockwise to close it
completely.
3. Now place the lifting levers
q
in the lifting lever
collet
t
.
4. Turn the lifting levers
q
clockwise until they are
secure against being pulled out.
5. On the first utilisation or after an extended
period of non-usage, first pump the Trolley Jack
without any loading (6-7 pump movements).
This distributes the hydraulic oil evenly again
inside the device.
Raising the vehicle
Important: Refer to the vehicle owner's
handbook to find out where the lifting points are
located. To avoid damage, the vehicle may only
be raised at these places.
1. Push the loading plate
w
to exactly in the
middle below the lifting point.
Note: Ensure that you place the vehicle jack in
such a position that the lifting levers
q
are not
under the vehicle.
2. To start, only pump until the loading plate
w
is
just touching the lifting point. This permits you to
make corrections if needed.
3. Now raise the vehicle until you have sufficient
clearance to position the axle stands.
4. Permit the vehicle to drop onto the axle stands in
that you slowly open the release valve
r
by
turning it in an anti-clockwise direction.
Lowering the vehicle
1. First raise the vehicle a little to remove the axle
stands.
2. Then, with the lifting lever
q
, slowly turn the
release valve
r
(anti-clock-wise) and carefully
allow the vehicle to descend.
3. As soon as the Trolley Jack is removed from
under the vehicle, the loading plate
w
can be
completely pressed down with the foot.
Cleaning and Care
Note: The hydraulic fluid may only be topped
up by a trained technician, or by customer
service.
The Trolley Jack can simply be cleaned with a
lightly oiled cloth.
Note: Do not alter the setting of the factory set
adjustment screw, this is only intended for
repairs carried out by customer services.
Storage
Lower the lifting arm completely. This permits space-
saving storage of the Trolley Jack.
IB_KH3046_DIE43192_LB5new 15.09.2009 13:22 Uhr Seite 15
17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Ultimate speed KH 3046 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Ultimate speed KH 3046

Ultimate speed KH 3046 Bedienungsanleitung - Deutsch, Holländisch, Französisch, Italienisch - 19 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info