Bedienungsanleitung Unold 28497 (Seite 21 von 80) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

485024

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

PROGRAMMING THE FILL QUANTITY

1. When programming the fill quantity, make

sure that there is enough milk in the milk

tank and always place a large enough con-

tainer under the milk spout.

2. To reset the appliance to the factory setting,

press buttons A and B simultaneously for

3 seconds.

Hot milk

3. You can change the quantity and duration

for preparation of the milk. With the factory

setting, the appliance prepares 150 ml of

hot milk in 30 seconds.

4. Press the A button for about 3 seconds until

the button starts to flash.

5. The appliance prepares hot milk until you

press the A button again.

6. From this point on, the appliance will always

prepare this amount of hot milk. The setting

can be adjusted from 5-60 seconds. When

set to 60 seconds the appliance prepares

about 300 ml of hot milk.

Frothed milk

1. You can change the quantity and duration

for preparation of the milk. With the factory

setting, the appliance prepares 100 ml of

frothed milk in 20 seconds.

2. Press the B button for about 3 seconds until

the button starts to flash.

3. The appliance prepares frothed milk until

you press the B button again.

4. From this point on, the appliance will always

prepare this amount of hot milk. The setting

can be adjusted from 5-30 seconds. When

set to 30 seconds the appliance prepares

about 100 ml of hot milk.

ENERGY SAVING (STAND-BY) MODE

1. If you do not use the appliance for 5 minu-

tes it automatically switches to stand-by

mode. All three buttons light up one after

the other.

2. To leave stand-by mode, press either button

A or B briefly.

3. You can extend the time after which the

appliance switches to stand-by mode to 30

minutes. To do this, switch the appliance

off.

4. Press the B button and switch the appliance

on. Keep the B button pressed until all but-

tons light up. Now the appliance will switch

to stand-by mode after 30 minutes.

5. If you wish to reset this setting to 5 minu-

tes, proceed as described above, but keep

button A pressed until all the buttons light

up.

SAFETY FUNCTION

If the front cover or the milk tank are removed from the appliance, the CLEAN button flashes quickly

and the appliance will not prepare any more milk.

CLEANING AND CARE

For hygienic reasons, the appliance

must be cleaned immediately after

every use. Otherwise, the remnants

of the milk could foster the growth of

health-harming germs.

Before you use the appliance cleaning program:

1. Fill the water tank with fresh, cold tap water

(max. 600 ml) and insert the tank in the

appliance.

2. Remove the milk tank from the appliance

and insert the cleaning cup.

3. To clean the appliance thoroughly, also fill

the milk tank with water (at least 200 ml,

but not more than 600 ml of water).

Short cleaning program

4. Before the first daily use of the appliance

and in between, if the appliance has not

been used for longer than 30 minutes.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Unold 28497 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info