484938
61
Zoom out
Zoom in
Vorherige Seite
1/68
Nächste Seite
61
SM2212
Your safety and that of others is extremely important.
This manual contains numerous recommendations and warnings for the safe use of this stacking system.
We recommend that you read and follow these instructions carefully and comply with the mentioned
safety warnings.
Before starting the installation, procure the required tools and parts.
Tools and equipment required
TORX®† T20 screwdriver
24 mm spanner
2 corner pieces of expanded polystyrene taken from the packing material
1 soft cloth and water with a mild detergent added
STACKING KIT
STACKING KIT SAFETY
A
B
C
INSTALLATION INSTRUCTIONS
EQUIPMENT AND PARTS
BUILT-IN OR CUPBOARD INSTALLATION
IMPORTANT: The washing machine/drier stack can also be installed in a niche or cupboard. To this end,
check the location of the water feed valves and earthed mains outlet socket. If any modifi cations are to
be made to the water supply valves, mains sockets or power supply cable, ask the assistance service
to carry out the work. The dimensions shown below refer to the minimum amount of space required.
An additional space should be left to facilitate the installation work and for maintenance purposes.
GB
SAFETY WARNING SYMBOL
This symbol warns of potential hazards that may be life threatening for you
and/or other persons. All the safety warnings are preceded by the safety warn-
ing symbol and the word “DANGER” or “WARNING”. These words have the
following meaning:
DANGER: If this warning is NOT complied with immediately, the action may lead
to serious injury or death.
DANGER: If this warning is NOT complied with, the action may lead to serious
injury or death.
All the safety warnings supply precise information on the potential hazard, the methods to use for reduc-
ing the risk of accidents and the consequences of any non-compliance with the instructions given.
Inside the product, an accessory is available to complete the installation and enable the drier to be
mounted on top of a front-loading washing machine, thus saving space. If the drier is stacked on top of
a washing machine the drier, the stacking kit HAS to be used . The installer will check if your washing
machine is suitable for this type of installation.
Parts supplied (fi g.17)
Open the kit and check that all the parts are present.
A. Foot anchors
B. Brackets
C. B. C. TORX®† screws
TORX®† IS THE REGISTERED TRADEMARK OF TEXTRON INNOVATIONS INC.
17
61

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Upo TC 7050 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info