Bedienungsanleitung UWATEC Galileo Terra (Seite 48 von 62) (Englisch)

550357

Zoom out

Zoom in

Vorherige Seite

1/62

Nächste Seite

3. Diving with Galileo

of 12 seconds. You can revert to the dive

computer screen at any time by pressing

and holding the right button.



NOTE:

- Proﬁ le, compartment saturation

and pictures can be viewed for a

maximum of 1 minute, after which

the regular dive computer screen

will appear again.

- If any warning or alarm is triggered

while you are viewing the proﬁ le,

compartment saturation or the

pictures, Galileo will immediately

revert back to the dive computer

screen.

3.4.5 Activating the backlight

To activate the backlight, press the right

button (marked LIGHT). The default

duration of the backlight is 6 seconds, but

you can set it between 2 and 12 seconds

in one second increments. You can also

set it to PUSH ON/PUSH OFF, which

means the light stays on until you turn it off

by pressing the button again.



NOTE:

The backlight is not available when

the REPLACE BATTERY warning

appears.

3.5 Diving with MB levels

Microbubbles are tiny bubbles that can

build up inside a diver’s body during any

dive and normally dissipate naturally during

an ascent and on the surface after a dive.

Dives within no-stop time and observance

of decompression stops do not prevent the

formation of microbubbles in the venous

blood circulation. Galileo has been equipped

with an enhanced UWATEC algorithm,

named ZH-L8 ADT MB, to reduce the

formation of these microbubbles.

This enhanced algorithm allows the user

to choose a level of conservatism over and

in addition to the worldwide proven safety

record of the standard ZH-L8 ADT algorithm.

There are ﬁ ve levels of added conservatism

(or MB levels), from L1 to L5, with L5 being

the most conservative and L1 being just a

bit more conservative than the standard

ZH-L8 ADT, here referred to as L0.

Choosing an MB level between L1 and

L5 makes the algorithm more conservative,

therefore the diver will have either shorter

no-stop times or deeper and longer

decompression stops (referred to as

level stops) than when diving with L0.

Consequently the body will either take up

less nitrogen (shorter no-stop dives) or will

be able to off-gas more before returning to

the surface (dives with level stops). Both

work towards reducing the amount of

microbubbles present in the body at the

end of the dive.

Please refer to section 2.3.1 for information

on setting the MB level.

3.5.1 MB Glossary

Deco stop: decompression stop as

requested by L0; mandatory.

L0: baseline algorithm corresponding to

ZH-L8 ADT.

L1: ﬁ rst and lowest level of added

conservatism.

L2: second level of added conservatism.

L3: third level of added conservatism.

L4: fourth level of added conservatism.

L5: ﬁ fth and highest level of added

conservatism.

Level stop: decompression stop as

requested by active MB levels L1 through

L5; not mandatory.

Reduced level stop: decompression stop

as requested by new active MB level, after

an MB level reduction has taken place due

to violation of level stop requirement.

ZH-L8 ADT: UWATEC’s adaptive 8-tissue

algorithm.

ZH-L8 ADT MB: UWATEC’s adaptive

8-tissue algorithm with MB levels (added

conservatism).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

UWATEC Galileo Terra Seite 48

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von UWATEC Galileo Terra

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info