36
lamp starts to flash. Make sure after clo-
sing that the doors are fully sealed. The
self-closing hinges assist this.
■ The cooling time for beverages and other
products can take up to 6 hours from
room temperature down to the cold
room temperature. The warmer they are
when put in, the longer this time will be.
■ Re-setting the temperature control has
no effect on the cooling rate, only on
the temperature reached.
■ Allow warm or really hot products cool
down outside the appliance.
■ Condensation can form on the glass
shelves if products are stored which emit
water vapour.
■ The electronic control defrosts the cold
room only about once per day. A cat ice
may be visible oftentimes at the back
board of the cold room – this is though
normal.
■ Be careful that products do not come
into contact with the rear wall of the
cold room so that they do not freeze to
it and that, during defrosting, water
does not get diverted into the cold
room.
■ When filling be careful that:
– Oil and fats do not come into contact
with the polymer parts and the door
seals.
– The coldest locations in the cold room
for any setting of the temperature
controller are at the back wall and
above the lowest shelf. Sensitive pro-
ducts should therefore be put on the
lowest shelf.
■ Example of how to use:
– Freeze and store foodstuffs and make
ice in the freezer compartment.
– On the shelves from top to bottom:
baked products, ready-made meals,
dairy products, meat and sausages.
– In the suspended trays from top to
bottom: butter and cheese, tubes,
small cans and eggs, large bottles.
– In the vegetable compartment: vegeta-
bles, fruit and salad.
Changing the LED lighting
Switch off the power supply: pull out
the power supply plug or deactivate
the fuse.
Click off the LED lighting (Figure +).
Disconnect the plug to the LED lighting
(Figure §). Please insert the new LED
lighting in the reverse sequence.
N.B.: Please only use original LED
lighting from the manufacturer.
+
§
