Bedienungsanleitung Vaillant VRC 470F (Seite 9 von 56) (Englisch)

665293

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

Installation

Installation instructions VRC 470f 0020124645_00 9

4 Installation

You can either integrate the radio receiver unit in the

boiler or install it separately on a wall. If you are wall-

mounting the radio receiver unit, you connect it to the

boiler via a 2-core eBUS cable.

You can fix the controller to a wall in the living area.

4.1 Checking the delivery

Quantity Component

1 VRC 470f controller

1 Radio receiver unit

1 VR 21 outside temperature sensor/transmitter

1 Wall-mounting base for radio receiver unit

1 Wall-mounting base for VRC 470f

2 Fastening material (2 screws and 2 wall plugs)

1 Battery set (4 x AA)

1 3-pin pin header connector

1 Operating instructions

1 Installation instructions

Tab. 4.1 Scope of delivery

4.2 Requirements for the installation site

4.2.1 Radio receiver unit

> Install the radio receiver unit in the boiler.

> If radio communication cannot be established when

the radio receiver unit is installed in the boiler, then

install it in a suitable position on a wall.

4.2.2 Controller

> Position the controller so that proper detection of the

room temperature is possible; e.g. on an internal wall

of the main living room, at a height of approx. 1.5 m

> If room temperature control is activated, advise the

operator that, in the room where the controller is

mounted, all the radiator valves must be fully open.

4.2.3 Outside temperature sensor/transmitter

The installation site of the outside temperature sensor/

transmitter should be:

– not fully protected from wind

– not particularly draughty

– not in direct sunlight

– not affected by heat sources

– on a north or north-west facing wall

– easily accessible so that the solar cell can easily be

cleaned

– a short distance from the radio receiver unit

> During start-up, check whether radio communication

between the outside temperature sensor/transmitter

and the radio receiver unit can be established.

> If radio communication is adversely affected by elec-

trical equipment or buildings, then choose a different

installation site for the outside temperature sensor/

transmitter.

4.3 Fitting the radio receiver unit in the boiler

Danger!

Risk of death from live connections!

When working in the control cabinet of the

boiler there is a risk of death from electric

shock. Continuous voltage is present on the

mains connection terminals, even if the main

switch is turned off!

> Switch the main switch off before working

on the control cabinet of the boiler.

> Disconnect the boiler from the mains

power by disconnecting the mains plug or

by de-energising the boiler via an isolating

device with a contact opening of at least

3mm (e. g. fuses or power switches).

> Secure the power supply against being

switched on again.

> Open the control cabinet only when the

appliance is disconnected from the power

source.

When fitting the radio receiver unit in the

boiler's switch box, follow the instructions for

fitting a controller given in the boiler installa-

tion instructions.

Install the radio receiver unit in the boiler as follows:

> Switch off the boiler.

> Ensure that the boiler is disconnected from the power

source.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Vaillant VRC 470F Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info