4
• The appliance must only be used for cutting hair and trimming beards. Any
other use is considered improper and not in compliance with the uses pre-
scribed by the manufacturer.
• Do not expose the appliance to temperatures below 0°C or above 40°C. Avoid
exposing the appliance to direct and prolonged sunlight.
• Do not leave the appliance on charge in wet places and do not recharge the
appliance when it is wet.
• Before using the appliance for the first time, charge the battery for 14 hours.
• The appliance comes equipped with a NiMH battery. To safeguard the envi-
ronment, do not dispose of the battery along with household refuse, but deli-
ver it to a disposal point for batteries.
• Danger of scratches or cuts. Do not use a comb or a set of blades if they are
damaged. Replace them immediately, as they may cause injury.
• Take care not to scratch the skin when handling the appliance with the set of
blades without combs.
USE
MAINS POWER SUPPLY
Connect the transformer (fig.1 – ref. 9) to the appliance by inserting the plug into
the appliance socket (fig.1 - ref.5). Plug the transformer into the mains.
Switch the appliance on using the switch (fig.1 - ref.3).
Switch it off after use.
Warning: if the appliance does not work with mains power when the battery
charge has run down completely, switch it off, recharge the battery for about five
minutes and then switch back on again, running on mains power.
SWITCHING ON AND SWITCHING OFF
To switch on the appliance turn the switch (fig. 1 – ref. 3) on position 1. To swit-
ch it off move the switch back to position 0.
RECHARGING THE BATTERY
• Before using the appliance for the first time, charge the battery for 14 hours.
For subsequent charges, allow the appliance to charge for at least 12 hours.
• Switch the appliance off using the switch (fig.1 - ref.3).
The battery can only be charged with the appliance switched off.
• Connect the transformer (fig.1 - ref.9) to the appliance by inserting the plug
into the appliance socket (fig.1 - ref.5).
Or connect the transformer to the base (fig.1 - ref.6) by inserting the plug into
the base plug (fig.1 - ref.7), then sit the appliance on the base.
• Plug the transformer into the mains.
• During charging the led (fig.1 - ref.4) lights up to indicate charging in progress.
• Only recharge the battery when you note a clear reduction in appliance power.
• When the battery is fully charged, the appliance can be used for 50 minutes
without connection to the mains.
00060452 INTERNO 7-11-2005 14:43 Pagina 4
