Bedienungsanleitung Varde Anholt (Seite 15 von 24) (Englisch)

813332

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

How to light and stoke a fire:

The first time you light up the stove the enamel will temper, and give off some smoke and a

slight smell. We recommend that you leave doors and windows open, as airing the room will

make the smell disappear. This tempering softens the enamel making it susceptible to damage.

Therefore exeercise caution and avoid touching the enamel. Likewise we recommend opening

the door to the stove at regular intervals for the first hours to prevent the insulations rope from

sticking to the enamel.

Never use highly inflammable fluids such as methylated sprit and petrol for lighting up!

We recommend a ”Top-Down” lightning, where you light the wood in the upper area of the com-

bustions chamber and not in the ground. This method is the most environmental metod to light

a fire. The metod will keep the glass clean. In the combustion chamber you make a cross (╬) of

4 small pieces of wood with a small distance between each one of them(0,7-1,1kg). On top you

of them you make another cross (╬) of 8-12 smaller sticks (0,4-0,7 kg.), on top of this firewood

and in between use 2-3 kildning blocks. In total approximate 1,5kg og woods. A thin layer of

ashes at the bottom of the stove makes lighting up a fire easier.

Before lighting up the stove, open ignition air on the ash-pan for access of primary air .The

throttle for the Combustion Air is drawn towards the right and hereby fully openes for combusti-

on air.

When the fire burns remember to close the the Ignition air again, or the stove and chimney

might become overheated and will invalidate the warranty. Also make sure the ash pan is closed

propper.

Hereafter the combustion air are ajusted to the need of heat. Be aware not to close to much for

the air supply, otherwise the fire will die, the fire must alway be bright and clear.

In most instances, however, you will have to achieve the best combustion air settings your-

self, as the height and draught of your chimney, as well as the quality of the firewood are deci-

sive factors in determining how your particular stove is best set.

If the stove nominal heat output is too large compared to the heat demand, you can reduce the

output as descriped here:

- use a smaller amount of wood than usual, for example. 0,9 to 1.2 kg. and preferably consist-

end of 3-4 smaller pieces of wood. Apply full air to ignite the wood properly, then you can

reduce the combustion air, perhaps down to approx. 60%. Be aware not to close to much for the

air supply, otherwise the fire will die, the fire must alway be bright and clear.

With this method it, (depending on the chimney, wood quality, etc. is possible to reduce the

stove heat output from a nominal 5,5 kW down to maybe 3 to 3.5 kW.

Please be aware that it can lead to poor combustion, if you regulate too much down the com-

bustion air, resulting in a lower efficiency and increased emission levels in the smoke.

(increasing pollution).

Tertiary air

If you are wondering why your stove is fitted with an gap in the rear vermiculite plate in the

combustion chamber, with small holes through the back steel plate, where air is running through

into the combustion chamber. This is merely a consequence of our newly developed combustion

system. We refer to these air ducts as the ‘tertiary air’, and will prove helpful as you install your

new Varde stove.

When refilling the stove with wood, we recommend opening the stove door only once embers

are left in the combustion chamber. Opening the door whilst the flames are still burning and

producing smoke and gas, might cause smoke to slip into the room instead of up the chimney.

Should you have some issuses with the lightning or the function, see section on troubleshoo-

ting.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Varde Anholt Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info