Bedienungsanleitung Varde Samso Wood (Seite 5 von 20) (Englisch)

813321

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Getting Started/User Instructions

3. Recommended Fuels

3.1 Wood Logs:

Burn only seasoned timber with a moisture content of less

than 20%. To ensure this allow cut wood to dry for 12 to 18

months.

Wood Length

Appliance Wood Length

All 300mm

Maximum diameter for all models: 100mm

Poor quality timber:

— Causes low combustion efficiency.

— Produces harmful condensation.

— Reduces effectiveness of the airwash and life of the

appliance.

Do not burn construction timber, painted, impregnated

/ treated wood, manufactured board products or pallet

wood.

4. Lighting the Appliance

4.1 For best results fully open the air controls.

4.2 Place firelighters or paper and dry kindling wood on the

base bricks.

A successful fire initially requires plenty of kindling to

establish a hot firebox and warm the chimney to aid flue

performance.

4.3 Light the paper or firelighters.

4.4 Leave the door slightly open as the fire establishes and the

glass warms to avoid build up of condensation.

4.5 Add larger pieces of wood.

Do not use full sized logs at this stage, build up gradually in

size. Too many logs may smother the fire.

4.6 Close the door and follow the instructions for Running

the appliance.

Refuel as detailed in Section 5.

5. Running the Appliance

5.1 Close the Air control to a third and adjust to control the

temperature in accordance with personal preference.

6. Refuelling the Appliance

6.1 Open the Air control fully.

Rake the embers evenly over the firebed to establish a

glowing firebed. If the firebed is low add a small amount

of kindling wood to help re-establish the fire.

Stack the logs in an open arrangement, see Diagram 2.

Compact Stacking

Open Stacking

Open stacking allows oxygen to easily reach every part of

the fire.

Compact stacking will make the wood burn slower as fire

can only reach the outside of the wood. This will cause the

fire to smoulder and produce smoke.

6.2 After refuelling:

Burn the new logs at a high temperature for a few

minutes before adjusting the burn rate using the Air

control.

Do not close the Air control until the fire is burning well.

6.3 Experience establishes settings to suit personal preferences.

6.4 Do not burn large amounts of fuel with the Air control

closed for long periods of time. This reduces the glass

cleaning effect, causes tars and creosotes to build-up in

the appliance and flue system and will produce excessive

amounts of smoke.

6.5 When in use, running the appliance at a high temperature

for a short period also reduces tars and creosote.

6.6 When running the appliance refuel little and often for

clean, efficient burning.

6.7 Wood burns best on a bed of ash (approx 1” deep).

A bright and clean firebox indicates the appliance is

burning well.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Varde Samso Wood Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Varde Samso Wood

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info