POWX075720DB EN
Copyright © 2021 VARO P a g e | 10 www.varo.com
9.13 Sawing special work pieces
Curved or round work pieces need to be secured against slipping.
Make sure there is no gap between the work piece and the fence (4) or the saw table (5).
9.14 Replacing the saw blade (Fig. 3)
Disconnect the tool from the outlet before working on the saw blade.
Wait a while before touching the saw blade. It can be very hot.
The teeth of the saw blade are very sharp.
▪ Loosen the locking screw from the removable blade guard and push the cover plate
upward.
▪ Press the spindle lock knob (22) to activate it, turn the saw blade (2) by hand until it
locked.
▪ Loosen the blade lock bolt by turning it clockwise using the Allan key (d).
▪ Remove the lock bolt, outer flange (a), saw blade (b)
▪ Remove the chips or sawdust from around the spindle and flanges.
▪ Fit the new saw blade, flanges and lock bolt. Check that the blade rotation direction
complies with that of the motor.
▪ Lower the removable blade guard until the cover plate is in the lowest position. Tighten the
locking screw from the removable blade guard.
When replacing the saw blade, you can tighten the slide bar with the
locking knob (20).
10 CLEANING AND MAINTENANCE
Before performing any work on the equipment, pull the power plug.
10.1 Cleaning
▪ Regularly clean the machine housing with a soft cloth, preferably after each use.
▪ If the dirt does not come off use a soft cloth moistened with soapy water.
▪ Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
Make sure no water can reach the inside of the power tool!
10.2 Connecting cable
If the connecting cable (or mains plug) is damaged, it must be replaced. Replacement of the
connecting cable should only be carried out by a qualified specialist (qualified electrician).
11 TECHNICAL DATA
