POWXG90430 EN
Copyright © 2021 VARO P a g e | 7 www.varo.com
6.2 Water connection
▪ Connection to the public mains according to regulations.
▪ Inlet hose can be connected to the water mains with a max. inlet pressure of 12 bars.
This high pressure washer is in Europe only allowed to be connected with the
drinking water mains, when an appropriate mains backflow preventer has been
installed, Type BA according to EN 1717. The length of the hose between the
backflow preventer and the high pressure washer must be at least 10 metres to
absorb possible pressure peaks (min diameter ½ inch).
▪ As soon as water has flown through the BA valve, this water is not considered to be
drinking water any more.
IMPORTANT! Only use water without any impurities. If there is a risk of
sand particles in the inlet water (i.e. from your own well), an additional filter
should be mounted.
6.3 Safety devices
▪ The unloader valve can reduce pressure if it exceeds pre-set values.
▪ Locking device on trigger gun (9): The trigger gun (8) features a locking device (9). When
the knob is activated, the trigger gun (8) cannot be operated.
▪ A thermal sensor protects the motor against overloading. The machine will restart after a
few minutes when the thermal sensor has cooled.
7 ASSEMBLY
This section will explain in details how to make you high pressure washer ready for use.
7.1 Assembly of the gun (Fig. 1)
▪ Insert the lance into the gun. Push and turn the lance clockwise onto the gun until hand
tight to lock it in place.
7.2 Assembly of a nozzle (Fig. 2)
▪ Attach nozzle into the end of the lance by pressing selected nozzle into place, it will make
a click sound when firmly in place .
▪ To remove nozzle, pull back on the collar on the lance and pull out the nozzle.
WARNING! Remember to change the nozzle when the gun is off, to ensure
that they do not accidentally eject with force during removal.
7.3 Assembly of the handle (Fig. 3)
▪ Insert the two ends of the handle assembly into the two holes at the top of the base as
shown. Press the hoodle until it is inserted into the hoodle hole,and the handle is fixed
when you hear a "CLICK" sound.
7.4 Assembly of the high pressure hook (Fig. 4)
▪ Screw the high pressure hook to the handle
8 OPERATION
8.1 Connection of garden hose (Fig. 5)
▪ Before attaching the water inlet connector to the pressure washer remove the plastic cap.
▪ Attach the hose connector (with built-in filter) to pressure washer.
▪ Connect the garden hose with a standard quick coupling
