Bedienungsanleitung Vauxhall Antara 2013 (Seite 2 von 2) (Englisch)

529287

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

Vehicle features Vehicle featuresVehicle features

Vehicle features

Longitudinal seat adjustment:

Pull handle, slide seat, release

handle.

Danger:

Do not sit nearer than 25 cm from

the steering wheel, to permit safe

airbag deployment.

Seat backrests:

Pull lever, adjust inclination and

release lever. Allow the backrest to

engage audibly.

Do not angle the backrest too far

back. We recommend a maximum

rake of approx. 25

Seat height:

Lever pumping motion:

up = seat higher

down = seat lower

Seat position:

Sit with buttocks as far back

against backrest as possible.

Adjust distance between seat and

pedals so that legs are slightly

angled when depressing pedals.

Head restraint adjustment:

Press the release button, adjust

height and engage.

The upper edge of the head

restraint should be at upper head

level.

Steering wheel adjustment:

Unlock the lever, adjust the

steering wheel, then engage the

lever and ensure it is fully locked.

Adjust only when vehicle is

stationary and steering wheel lock

is released.

Interior mirror:

Swivel lever on underside of mirror

housing to reduce dazzle at night.

Automatic anti-dazzle interior

mirror:

Dazzle is automatically reduced.

Press button on mirror housing to

turn function on; button

illuminates.

Do not cover the light sensors on

the mirror housing or hang

anything on the mirror.

Exterior mirrors:

Select the relevant exterior mirror

by turning the control to left (L) or

right (R). Then swivel the control to

adjust the mirror.

Lighting:

Turn light switch:

0 Off

8 Sidelights

9 High or low beam

AUTO Automatic light control

Press light switch:

> = Front fog lights

r = Rear fog light

Turn thumb wheel:

q = Headlight range

adjustment

k = Instrument illumination

Automatic light control:

Turn light switch to AUTO position.

With the engine running, low beam

switches on automatically

depending on outside light

conditions.

For reasons of safety, the light

switch should always remain in the

AUTO position.

Do not cover light sensor on top of

the instrument panel to ensure

proper function of automatic light

control.

Daytime running lights:

Daytime running lights increase

visibility of the vehicle during

daylight.

The lights operate automatically

when the ignition is switched on.

Headlight flash, high beam and

low beam:

Headlight flash = Pull lever

High beam = Push lever

Low beam = Pull lever

Headlight range adjustment:

With low beam 9 switched on,

adapt headlight range to suit

vehicle load and prevent dazzling

of other road users.

Turn thumb wheel

q to required

position.

For vehicles without/with

automatic level control system:

Front seats occupied = 0/0

All seats occupied = 1/1

All seats occupied and

load compartment laden = 1/2

Driver’s seat occupied and

load compartment laden = 2/3

Turn and lane-change signals:

Lever up = Right turn signal

Lever down = Left turn signal

If the lever is moved past the

resistance point, the turn signal is

switched on constantly. When the

steering wheel is moved back, the

turn signal is automatically

deactivated.

For three flashes, e.g. when

changing lanes, press the lever until

resistance is felt and then release.

Move lever to resistance point and

hold for longer indication.

Switch the turn signal off manually

by moving the lever to its original

position.

Rear window wiper/washer:

Move the lever to activate the rear

window wiper.

Push lever = Wiper on

Pull lever = Wiper off

To activate rear window washer

system, press and hold button on

end of lever. Washer fluid is

sprayed onto rear window and the

wiper wipes a few times when the

button is released.

Do not use if the rear window is

frozen.

Switch off in car washes.

Hazard warning flashers:

Operated with button

¨ on the

instrument panel.

In the event of an accident where

the airbags are deployed, the

hazard warning flashers are

activated automatically.

Windscreen wiper:

O =Off

$ = Timed interval wipe or

automatic wiping with

rain sensor

% =Slow

& =Fast

For a single wipe when the

windscreen wiper is off, press the

lever down.

Do not use if the windscreen is

frozen. Switch off in car washes.

Heated rear window, heated

exterior mirrors:

The heating is operated by

pressing button R

Ü.

LED in the button illuminates.

Heating works with the key in

ignition switch position ACC or ON

and switches off automatically

after a short time.

To avoid discharging the battery,

operate only with the engine

running.

Do not operate when you are just

starting the vehicle or if there is a

build up of snow or ice on the

exterior mirrors.

Demisting and defrosting the

windows:

Air distribution to V (or l).

Cooling A/C (or

n) and air

recirculation 4 are switched on

automatically to improve

defrosting efficiency (air

recirculation 4 is automatically

switched off in vehicles with

electronic climate control).

Set temperature to highest level.

Set fan speed to highest level.

Switch on heated rear window R

Ü.

Close centre air vents, open side air

vents and direct them towards the

door windows.

Power seat adjustment:

Move front switch forwards/

backwards to adjust seat position.

Move front and rear of front switch

to adjust height of seat cushion.

Move upper part of rear switch

forwards/backwards to adjust seat

backrest.

Seat belt:

Withdraw seat belt from retractor,

guide it untwisted across the body

and insert latch plate in belt buckle.

To release belt, press red button on

belt buckle.

Lumbar support:

Adjust lumbar support to suit

personal requirements using the

lever.

Move lever forwards/backwards to

increase/decrease lumbar support.

Seat belt height adjustment:

Squeeze release buttons together

and slide adjuster up or down to

desired position.

Ensure sliding height adjuster is

latched into position.

Do not adjust height whilst driving.

Power windows:

With the ignition on, power

windows are operated via the

switches in the door.

Front switches operate the front

windows and rear switches operate

the rear windows.

Incremental operation:

 Push switch briefly = To open

 Pull switch briefly = To close

Automatic function:

Push or pull switch for longer.

Window moves up or down

automatically with safety function

enabled. To stop movement,

operate the switch once more in the

same direction.

If the window glass encounters

resistance above the middle of the

window during automatic closing,

it is immediately stopped and

opened again.

Child safety system for rear power

windows:

Press switch

z to deactivate rear

door power windows.

To reactivate, press switch

again.

With the child safety system on,

rear door power windows can only

be operated via the switches in the

driver’s door.

Folding in exterior mirrors:

Manually:

Apply slight pressure to outer edge

of mirror housing.

Electrically:

With key in ACC or ON position,

press button n and both exterior

mirrors will fold in.

Press button n again to fold

mirrors back to the driving position

before starting-off.

For pedestrian safety, exterior

mirrors will swing out of their

normal mounting position if they

are struck with sufficient force.

Reposition mirrors before driving.

Windscreen and headlight

washer:

Pull lever. Washer fluid is sprayed

onto the windscreen.

If the lever is held for longer, the

wiper also operates briefly after the

lever is released and once more

after a brief delay.

If the headlights are on, washer

fluid is also sprayed onto the

headlights. The headlight washer

system can only be operated again

after a brief delay.

In vehicles with rain sensor, keep

the sensor area (located in the area

around the interior mirror) clean by

operating the windscreen washer

regularly.

Front fog lights:

With ignition on and light switch set

to 9 or 8, press switch

> to

activate front fog lights; control

indicator

> illuminates in the

instrument cluster. Press switch

again to turn off.

Rear fog light:

With ignition on and light switch set

to 9 (or 8 with front fog lights

on), press switch

r to activate rear

fog light; control indicator

illuminates in the instrument cluster.

Press switch

r again to turn off.

With light switch in AUTO position,

switching on front or rear fog lights

will switch on low beam and

sidelights automatically.

Vauxhall Antara 2013 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Vauxhall Antara 2013

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info