Bedienungsanleitung Vauxhall Meriva 2010 (Seite 1 von 2) (Englisch)

529255

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

Vehicle features Vehicle features

Meriva

Quick Reference Guide

Refer to Owner’s Manual for detailed information.

Illustrations may depict left-hand drive vehicles.

Operation is similar for right-hand drive vehicles.

Depending on the model variant, special equipment

and accessories, the scope of equipment on your

vehicle may differ from the descriptions in this guide.

TS 1692-B-10 / KTA 2692

February 2010

*KTA-2692*

1. Light switch, fog lights,

headlight range adjustment,

instrument illumination

2. Side air vents

3. Turn signals, headlight flash,

low beam, high beam,

exit lighting, parking lights

4. Cruise control

5. Instruments

6. Horn, driver airbag

7. Driver Information Center

8. Steering wheel controls

9. Wiper and washer systems

10. Centre air vents

11. Infotainment system

12. Sensor for climate control

13. Info-Display

14. Central locking system,

hazard warning flashers,

control indicator for airbag

deactivation

15. Traction Control,

Electronic Stability Control,

ultrasonic parking assist,

Deflation detection system

16. Front passenger airbag

17. Glovebox, fuse box

18. Climate control system

19. Selector lever

20. Electrical parking brake

21. Accelerator pedal

22. Ignition switch with

steering wheel lock

23. Brake pedal

24. Clutch pedal

25. Steering wheel adjustment

26. Storage compartment

27. Bonnet release lever

To open the tailgate, push the

touchpad switch under the tailgate

moulding.

Locking

Close doors, load compartment

and fuel filler flap.

Press button

e to lock doors and

activate anti-theft alarm system.

Press button

e twice within

10 seconds to deadlock all doors.

Electronic immobiliser is activated

automatically when key is removed

from ignition switch.

Unlocking

Press button

c to unlock doors,

load compartment and fuel flap.

Open doors by pulling the handles.

Vehicle security

Manual transmission:

Reverse: With vehicle stationary,

depress clutch pedal, press the

release button on the selector lever

and engage the gear.

If the gear does not engage, set the

lever to neutral, release the clutch

pedal and depress again; then

repeat gear selection.

Do not grind the clutch

unnecessarily.

When operating, depress clutch

pedal fully. Do not use the pedal as

a foot rest.

Automatic transmission:

P =Park

R = Reverse

N =Neutral

D =Drive

Manual mode: Move selector lever

from D to the left.

+ = Higher gear

- = Lower gear

The selector lever can only be

moved out of P when the ignition is

on and the brake pedal is applied.

To engage P or R, press the release

button on the selector lever.

Starting the engine:

 Turn key to position 1

 Move steering wheel slightly to

release steering wheel lock

 Manual transmission:

Depress clutch and brake pedal

 Automatic transmission in P or N

with brake pedal depressed

 Do not accelerate

 Diesel engines: turn key to

position 2 for preheating and

wait for ! to extinguish

 Turn key to 3 and release

Electrical parking brake:

Pull switch J, parking brake

operates automatically with

adequate force. For maximum

force, e.g. when parking with trailer

attached or on inclines, pull switch

J twice.

The parking brake can always be

activated, even if the ignition is off.

Before leaving the vehicle, check

parking brake status.

To release, switch on ignition, keep

brake pedal depressed and push

switch J.

Drive away function

Depressing clutch pedal or

engaging drive gear D (automatic

transmission) and then depressing

the accelerator pedal releases the

electrical parking brake.

Opening the bonnet:

Pull release lever below instrument

panel on driver’s side and return it

to its original position.

Press the safety catch beneath the

bonnet (located slightly to the right

of centre) and raise the bonnet.

Secure the bonnet in the upright

position using the support rod

located at the front of the engine

compartment.

Closing the bonnet:

Before closing bonnet, press

support rod into its holder.

Lower bonnet and allow it to drop

into the catch. Check bonnet is

engaged.

Refuelling:

Before refuelling, switch off engine

and any external heaters with

combustion chambers (identified

by sticker on fuel filler flap).

Switch off mobile phones.

Fuel is flammable and explosive.

No smoking! No naked flames or

sparks.

If you can smell fuel in your vehicle,

have the cause of this remedied

immediately by a workshop.

Fuel filler flap is located at right

rear side of vehicle.

The fuel filler flap can only be

opened if the vehicle is unlocked.

Pull flap at the recess and open.

The fuel filler cap can be retained in

the bracket on the filler flap.

Wipe off any overflowing fuel

immediately.

Petrol engines - use unleaded fuel

that complies with DIN EN 228.

Diesel engines - use diesel fuel that

complies with DIN EN 590.

Fuel tank capacity - 54 litres.

Engine oil:

The engine oil level is checked

automatically and a vehicle

message (Code 79) appears in the

Driver Information Center (DIC) to

warn that engine oil needs topping

up immediately.

However, check engine oil level

manually every 300 miles or prior to

long journeys, to prevent damage

to the engine.

Check with vehicle on a level

surface. Engine must be at

operating temperature and

switched off for at least 5 minutes.

Pull out dipstick, wipe it clean,

insert to the stop on the handle,

pull out and read engine oil level.

Insert dipstick to stop on handle

and make half a turn.

Caution:

It is the owner’s

responsibility to maintain the

correct level of an appropriate

quality oil in the engine.

Tyre pressure:

Check tyre pressures, including the spare, every 14 days and prior to any long journey; tyres should be

checked when cold. This also applies to vehicles with tyre pressure monitoring system.

Always inflate the spare tyre to the value specified for full load.

The ECO tyre pressure serves to achieve the smallest amount of fuel consumption possible.

Tyre pressures are shown on a label on the front left door frame.

Tyre pressure data applies to both summer and winter tyres. Incorrect tyre pressures will impair safety, vehicle

handling, comfort and fuel economy and will increase tyre wear.

Refer to Owner’s Manual for approved tyres.

Tyre pressure (psi)

Comfort setting for load of

upto 3 people

Engine

Tyres Front Rear

A14XER All tyres 33 30

A14NEL, All except below33 30

A14NET 225/40 R18 36 33

A13DTC All tyres 33 30

A17DT All except below 36 33

225/40 R18 39 36

All Temporary spare 61 61

Tyre pressure (psi)

ECO setting for load of

upto 3 people

Engine

Tyres Front Rear

A14XER All tyres 41 38

A14NEL,All tyres 4138

A14NET

A13DTC All tyres 41 38

A17DT All tyres 43 41

All Temporary spare - -

- = Do not use ECO tyre pressure

setting for this tyre.

Tyre pressure (psi)

For full load

Engine

Tyres Front Rear

A14XER All tyres 36 46

A14NEL, All except below36 46

A14NET 225/40 R18 39 46

A13DTC All tyres 36 46

A17DT All except below 39 46

225/40 R18 41 46

All Temporary spare 61 61

Vauxhall Meriva 2010 Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Vauxhall Meriva 2010

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info