Bedienungsanleitung Vauxhall Zafira 2006 (Seite 2 von 2) (Englisch)

529278

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

Vehicle features

Vehicle features Vehicle features

Lighting switch (continued):

AUTO Automatic dipped beam

activation 3

k Instrument illumination

q Headlight range adjustment

Correct adjustment of the headlight

range reduces dazzle for other road

users:

For vehicles without level control system

z Front seats occupied = 0

z All seats occupied = 1

z All seats occupied and

luggage compartmentload = 2

z Driver’s seat occupied and

luggage compartmentload = 3

For vehicles with level control system

z Front seats occupied = 0

z All seats occupied = 1

z All seats occupied and

luggage compartmentload = 1

z Driver’s seat occupied and

luggage compartmentload = 2

Door-to-door lighting 3:

Turn key to o and remove, pull the

indicator stalk towards the steering

wheel.

The dipped headlights remain on for 30

seconds after the door is closed.

Automatic dipped beam activation 3:

light switch to AUTO: Dipped beam

comes on automatically when the

engine is running if outside light

conditions warrant such.

The exterior lights switch off when the

ignition is switched off.

For reasons of safety, the light switch

should always remain in the AUTO

position.

Seat adjustment:

1. Seat backrest tilt (approx. 25° max)

2. Seat height

3. Seat position

Important

: Do not sit nearer than

10 inches (25 cm) from steering wheel,

to permit safe airbag deployment.

Lumbar support:

Adjust lumbar support to suit personal

requirements: turn handwheel.

Do not lean on seat backrest whilst

adjusting it.

Seat inclination 3:

Pull lever on front of seat, adjust

inclination, release lever and audibly

engage seat in position.

Adjust the inclination by distributing

body weight.

Folding the front passenger seat

backrest forward 3:

Lower passenger seat head restraint.

Lift release lever, fold backrest forwards

and lock, slide seat forwards

To raise seat, slide back to stop, lift

release lever and raise backrest until it

audibly latches.

Seating position:

Adjust driver’s seat such that, with the

driver sitting upright, the steering wheel

is held in the area of its upper spokes

with the driver’s arms slightly bent. Push

front passenger’s seat as far back as

possible.

Adjusting head restraint height:

Grip headrest at sides, tilt forward and

move into position.

To remove head restraints:

Release the two springs by pressing

them and detach the head restraint. The

middle of the head restraint should be at

eye level.

Fitting seat belts (continued):

Pull smoothly from inertia reel, guide

over shoulder and engage in buckle.

Belt must not be twisted at any point.

The lap belt must fit snugly across the

body. The seat backrest must not be

inclined too far back (approx. 25° max.).

To release belt, press red button on belt

buckle.

Adjusting exterior electric mirrors3:

Four-way switch on driver’s door

Press switch for left or right-hand mirror:

four-way switch operates the

corresponding mirror.

Adjusting interior mirror:

Swivel mirror housing.

Swivel lever on underside of the mirror

housing to reduce dazzle at night.

Swinging exterior mirror

Manually: Press lightly

Electric 3: Press n button to swing in

both exterior mirrors.

Press button n again for the exterior

mirrors to assume their original position.

Lighting switch:

0 Off

8 Parking lights

9 Dipped or main beam

0 Courtesy light (pull)

> Front fog lights 3 (press)

r Fog tail light (press)

Headlight range adjustment

Manual headlight range adjustment 3

With dipped beam switched on, adjust

headlight range in four steps to suit

vehicle load. Turn adjustment wheel to

the required position.

Fog lights:

Front fog lights

Press >,

> illuminates in instrument

panel. Press again to turn off.

Fog tail light:

Press r, r illuminates in instrument

panel. Press again to turn off.

Ignition must be switched on and light

switch in position 9 or 8.

Instrument illumination k,

information display illumination:

Brightness can be adjusted when the

exterior lights are on:

Push to release knob k Turn clockwise or

anticlockwise and hold until desired

brightness is obtained.

Operating turn signal lights:

Right = Stalk all the way up

Left = Stalk all the way down

Turn signal stalk returns to its original

position after use. When steering wheel

is straightened up, turn signal lights are

automatically cancelled.

Activating main or dipped beam:

Main beam = Move stalk forward

Dipped beam = Stalk forward again

or pull stalk towards

steering wheel

Pull stalk towards steering wheel to

operate headlight flash.

Windscreen wiper:

Gently tap stalk upward

§ = Off

$ = Timed interval wipe

% = Slow

& = Fast

Operating windscreen wash system

and headlight wash system 3:

Pull stalk towards steering wheel.

The wiper swipes for a few strokes.

At low speeds, there is a one-time

post-wash swipe.

The headlight wash system can be

operated when the lights are on.

On vehicles fitted with a rain sensor 3,

keep the sensor area clean by operating

the system regularly.

Hazard warning lights:

On = Press ¨

Off = Press ¨ again

Pushbutton surface is illuminated with

the ignition switched on.

Heated rear window,

heated exterior mirrors Ü:

Operational only with engine running.

Heating is switched off automatically

after approx. 15 minutes.

Clearing misted or icy windows:

Set air distribution to l, turn

temperature and fan speed rotary

switches clockwise. Open air vents and

direct side air vents towards the

windows. Air conditioning system 3,

also press n.

Air conditioning system n 3:

Operate only with engine running and

the fan running:

On = Press n

Off = Press again n

Adjust temperature and fan speed

accordingly.

Air conditioning system n 3

continued:

When cooling (AC compressor) is

active, air is cooled and dehumidified.

If cooling or dehumidification is not

desired, switch off cooling in order to

save fuel.

At low outside temperatures the

cooling unit switches off automatically.

Air recirculation system 4:

The recirculation switch 4 is used to

set ventilation system in recirculation

mode.

If fumes penetrate from outside:

temporarily switch on air recirculation

system 4.

The quality of air deteriorates which

may cause the vehicle occupants to

feel drowsy. Only use for short periods.

To switch off press 4 again.

Steering wheel adjustment:

Move lever down, adjust height, move

lever up, engage.

Adjust steering wheel only when vehicle

is stationary and steering column lock is

released.

Fitting seat belt:

Adjust height such that the belt passes

over the wearer's shoulder and rests

against the shoulder. It must not pass

over the neck or upper arm.

Pull belt slightly, press button on

adjuster, and slide up to correct height.

Allow anchorage to lock audibly into

position.

Vauxhall Zafira 2006 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info