How to Assemble / How to Operate
5
3. How to Assemble
IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet before assembling or
removing the accessories.
1. Insert the flexible hose into the inlet on the main
body of the vacuum cleaner. Push until it clicks into
position. (Fig 3/1)
2. Push the telescopic extension tube on to the end of
the handle (Fig 3/2)
3. The telescopic extension tube can be lengthened or
shortened by pushing the button in and sliding the
tube apart or together as required (Fig 3/3).
4. Fit the combination floor head by pushing on to the
extension tube
4. How to Operate
Fully unwind the power cord. A yellow mark on the
power cord indicates the recommended length. Do not
exceed the cord length beyond the red mark.
1. On/off Button
Insert the power plug into the electrical outlet. Make
sure the vacuum cleaner is switched off.
Press the on/off button located on the top of the
vacuum cleaner to switch on the vacuum cleaner and
press the button again to turn the vacuum cleaner off.
2. Carpet Cleaning
For carpet and rug cleaning, press the rocker switch on
the combination floor head to raise the brushes
3. Hard Floor Cleaning
For hard floor cleaning, press the rocker switch on the
combination floor head to raise the brushes.
4. Cord Rewind
To rewind the power cord, press the cord rewind
button, located on the top of the vacuum cleaner and
guide the power cord with one hand. This will prevent
the cord from whipping which could cause damage or
injury.
5. Variable power
Located between the on/off and cord rewind buttons
there is a variable power dial. Turn this clockwise and
anti-clockwise to adjust the suction power.
6. Dust full indicator
This is located between the on/off and cord rewind
buttons and will light up when the dirt container is full.
7. Carry Handle
Use the carry handle located on the top of the vacuum
cleaner to move from room to room
8. Hose Storage
For convenience, there is a slot located at the back of
the vacuum cleaner where the floor tool and hose can
be parked for carrying and storage.
5. Accessories
1. The accessories can be attached directly to the
handle by removing the telescopic extension tube and
pushing on the desired accessory.
The accessories can also be attached to the telescopic
extension tube for extra reach. Remove the
combination floor head and push on the desired
accessory.
Crevice tool: for crevices, corners, cracks etc
Dusting brush: this attachment can be slid on to the
upholstery tool for delicate surfaces
Upholstery tool: for carpet, upholstery stairs etc
T
urboT
ool:
for pet hair
, upholstery and stair cleaning.
The TurboTool should be pulled backwards for
optimum cleaning.
Fig.3/1
Fig.3/2
Fig.3/3
Fig.3/4
