1 Vacuum the area you intend to wash
2 Remove the motor unit, cone filter unit, hose, dust
bag connector with bag attached and vacuuming tool
Stop the dust coming out of the dust bag by closing the
shutter on the dust bag connector and leaving it on the bag.
3 Push in the connector on the end of the hose
Turn it clockwise to lock.
4 Fill the clean water bucket with warm water, to the
level marked on it. Fit the clean water bucket into
the dirty water bucket.
5 Add VAX Carpet Cleaner to the clean water
Refer to the instructions on the carpet cleaner bottle.
6 Unclip the transparent tube on the bottom of the
motor unit
Place it in the bottom of the washing solution.
7 Fit the motor unit (make sure the transparent tube
is not trapped when you do this)
Secure both side clips.
8 Fit the transparent tube valve
Push it hard and turn it clockwise to lock.
9 Fit the Extension tubes and the Extension tube
adaptor together
10 Ensure that all tabs are locked
11 Fit the washing tool and push the short transparent
tube into it
YOU ARE NOW READY TO START WASHING
Getting ready to wash
5
Tip
You should pour VAX Defoamer into the dirty water bucket
(through the central hole in the clean water bucket) if your carpet has
been previously washed with a high foaming shampoo. VAXDefoamer is
available through your VAXService Agent or from VAXdirect.
