Bedienungsanleitung VDO Dayton CD 2253 (Seite 5 von 16) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Finnisch)

7266

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

BEFORE YOU START....

Thank you for purchasing this VDO Dayton product

which has been designed and manufactured to the

highest standards and subjected to rigorous

testing.

Kindly familiarise yourself with the product by

reading this user manual. Keep this manual handy

in your car for future reference.

This manual covers the following models:

CD 2203, CD 2253, CD 2703, CD 2803.

The main differences between them are as follows:

MP3 playback - only CD 2703, CD 2803.

Navigation mute - only CD 2703, CD 2803.

Speed Dependant Volume Control (SDVC) -

only CD 2253, CD 2703, CD 2803.

IR Remote Control included - only CD 2803.

3D surround sound - only CD 2803.

2 channel Pre-out - only CD 2203, CD 2253,

4 channel Pre-out - only CD 2703, CD 2803.

News Function - only CD 2703, CD 2803.

Separate Source equalization - only

CD 2703, CD 2803.

CD Changer control or Auxiliary - only CD 2203,

CD 2253, CD 2803.

Graph - only CD 2803.

Note : We reserve the right to make changes and

improvements to any of the products described in

this guide without prior notice.

ENVIRONMENT

This booklet is printed on low-chlorine recyclable

paper.

IMPORTANT

This device has been designed and produced

according to applicable Safety Regulations. Please

read carefully the instruction manual and use the

device as intended.

PREVENTIVE MAINTENANCE

Cleaning the connectors

To ensure good connection between the set and

the detachable front, it is advisable to clean the

connectors with a cotton swab slightly moistened

with cleaning fluid or alcohol periodically.

CONTENTS PAGE

INSTALLATION ................................................. 5

PREPARATION ................................................. 5

MOUNTING ...................................................... 7

FRONT PANEL PRESENTATION ..................... 8

SECURITY ........................................................ 9

AUDIO ............................................................... 9

RADIO ............................................................. 10

RADIO DATA SYSTEM (RDS) ON FM ........... 11

CD, MP3* AND CDC* ..................................... 12

SPECIAL FUNCTIONS ................................... 13

SAM (Software Access Mode) ........................ 14

TROUBLE SHOOTING ................................... 16

INSTALLATION

If your car is equipped with ISO connectors, simply

insert them in the connectors of the car radio. If

not, you can use an adaptor cable (Refer to the

table on the separate installation manual). Ensure

all cables are installed so that they cannot be

damaged by sharp edges or moving parts.

PREPARATION

Voltage and polarity: The set must be connected

to a 12V car battery with negative terminal to earth

(car chassis). Installation in vehicles not fulfilling

these requirements could result in malfunction,

damage or fire.

Warning: To prevent short-circuiting,

disconnect the negative car battery terminal until

the set has been mounted and connected (fig.

1 See separate installation card).

CONNECTOR A** (fig. 2)

Power supply connections

• Red wire A7 : Connect to a permanent 12V

supply. This is the main power supply. Ensure

this connection can handle a current of 10A.

•Yellow/red wire A4 : Connect to a switched 12V

supply (switched on/off by car ignition).

• Brown wire A8: Connect to earth (car chassis).

Optional connections (fig. 2)

• SDVC (Speed Dependent Volume Control)*:

SDVC automatically increases and decreases

the volume as a result of the car's speed.

• Connect pin A1 to a signal from the speedometer

of your car. Some cars are already prepared for

it (e.g. certain VW & Vauxhall/Opel cars), please

consult your dealer.

If not, you may need a more detailed installation

requiring extra equipment to enable your car to

become compatible.

** For this accessory, see your dealer

* Depending on version

Complies with 21 CFR 1040.10

004-16 Mid_Eng 12/17/02, 12:49 PM5

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

VDO Dayton CD 2253 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info