Bedienungsanleitung VDO Dayton CD 2803 (Seite 9 von 16) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Finnisch)

7270

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

* Depending on version

SECURITY

For theft protection this set is provided with the

following security features :

DETACHABLE FRONT

Take the detachable front with you when leaving

the car. Keep it in its protective box.

Always replace the detachable front before starting

to drive.

Removing the front (See page 3, figure B)

• Press to flip down the detachable front.

• Pull at the left hand corner of the detachable

front to remove the front.

Replacing the front (See page 3, figure C)

• Insert the detachable front starting with the right-

hand side of the set.

• Push the detachable front until it clicks into

position.

LOCKING THE DETACHABLE FRONT (See

page 3, figure E)

The detachable front can be locked by a D2 x10

screw.

• Remove the trimplate

• Flip down the detachable front.

• Insert a D2 x10 screw (inside the accessories

bag) in position

SECURITY LIGHT

• The LED flashes when the detachable front is

removed when the ignition is off. You can switch

off the flashing warning light. See 'SAM' (page

14), option 'LED' .

IDENTIFICATION NUMBER

This set has a unique identification number (stated

on the 'Security card'). This card is required as a

proof of ownership when the set is stolen, when

the detachable front is lost or when requesting

service.

• Remove the 'Security card' before installing the

set. Do not keep the 'Security Card' in your car.

AUDIO

ON/OFF

• Press to switch on the set. Press

for more than 2 seconds to switch off the set.

VOLUME

Please make sure you can still hear the traffic

(horns, sirens........)

• Press

to adjust the volume. The volume

automatically increases or decreases if the

SDVC connection has been installed and

selected (See INSTALLATION, page 5).

Note : You can adjust the start-up volume. When

the start-up volume is set to maximum level, it

may be extremly loud when you switch on the

set. See 'SAM' (page 14), option 'START'.

MUTE

• Press to mute/demute the sound when

the set is switched on.

Note : You can adjust the mute level.The volume

may be louder during mute when the mute level

is higher (e.g. 16) than the current volume (e.g.

5). See 'SAM' (page 14), option 'MUTE'.

3D SURROUND SOUND* (only applicable for

CD, CD Changer* and MP3*)

• Press * for more than 2 seconds to

activate/deactivate 3D surround sound.

AUDIO MODE SETTING

• Press * or to select

desired audio mode.

• Press or to adjust the selected

audio mode.

– BASS : Bass (-7...+7)

– TRE : Treble (-7...+7)

– BAL : Balance (-7...+7)

–FAD : Fader (-7...+7)

– Sound Style (BASS-TRE, ORIGINAL, JAZZ,

VOCAL, POP, CLASSIC, ROCK)

After 5 seconds the display goes back to the

last mode of operation.

Adjustment of Bass and Treble setting is only

possible when BASS-TRE is selected as the

sound style.

Sound style are set for each source* (Radio,

CD/MP3* and CD Changer*).

BASS BOOST SYSTEMS

• Press to select desired bass boost (not

applicable when ORIGINAL is selected as the

sound style).

004-16 Mid_Eng 8/15/02, 6:48 PM9

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

VDO Dayton CD 2803 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info