Bedienungsanleitung VDO Dayton pc 5200 (Seite 22 von 30) (Englisch)

162090

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

Troubleshooting

In very rare cases, it can happen that your

multimedia system does not function as you

would expect. Before you contact customer

service, please read the detailed operating

instructions on the DVD-ROM and review the

following checklist, as an apparent malfunc-

tion can possibly be remedied quickly.

Symptoms Possible cause/remedy

System does not start, screen dark. Ignition switched off:

• Switch on the ignition.

Ignition is already switched on, and system is on stand-by:

• Press one of the cursor buttons, the OK button, or the menu button

on the remote control.

The system switches itself off after a

period of normal operation.

At extremely high or low temperatures, the system is automatically

switched off to protect against damage. It switches on again as soon

as the temperature has returned to normal.

System does not react to actuation of

the buttons if remote control is not in

its active holder.

No batteries inserted or batteries empty:

• Replace the batteries in the remote control, or install the remote

control in its holder.

Guidance information not audible. • Check whether “Audible information” has been activated in the

“Settings” menu.

• Check whether “Volume” in the “Settings” menu is set to minimum.

If no external speaker is connected:

• Check the volume setting of the monitor.

Some of the symbols or specifications

shown in the operating instructions are

not displayed in the status line.

• Activate the required specifications in the “Settings

–> Screen config. –> Status line” menu.

Colour of the satellite symbol in the

status line is constantly red.

No GPS reception.

• Ensure that the GPS antenna is not obscured by any objects.

Current time in the status line is incor-

rect.

• Set the correct time zone in the “Settings –> General settings –>

Measuring units” menu.

Guidance is not accurate. An accuracy of 50 m falls within the specified tolerance limits. Please

contact an authorised dealer if greater inaccuracies occur repeatedly.

Displayed position does not correspond

to actual vehicle position.

Problems with GPS reception persist. The position is corrected auto-

matically as soon as GPS reception is satisfactory.

• If necessary, wait a few minutes.

• Have your installation workshop verify that the mounting angle of

the navigation computer has been set correctly.

Directions do not correspond to the ac-

tual traffic conditions.

It is possible that the car’s position as calculated by the navigation

system is not currently correct. Traffic routing may have been

changed and no longer corresponds to the information on the navi-

gation data medium.

“TMC” logo in the status line is perma-

nently red, and no traffic information

is displayed on the map.

Poor/disrupted TMC reception.

OPERATION SETUP INSTALLATIONCONTENTS

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

VDO Dayton pc 5200 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info