Bedienungsanleitung Velleman DB2 (Seite 2 von 10) (Deutsch, Englisch, Holländisch, Französisch, Portugiesisch, Spanisch, Polnisch)

720369

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

DB2

V. 04 – 20/03/2018 2 ©Velleman nv

USER MANUAL

1. Introduction

To all residents of the European Union

Important environmental information about this product

This symbol on the device or the package indicates that disposal of the device after its lifecycle could

harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it

should be taken to a specialized company for recycling. This device should be returned to your

distributor or to a local recycling service. Respect the local environmental rules.

If in doubt, contact your local waste disposal authorities.

Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into service. If

the device was damaged in transit, do not install or use it and contact your dealer.

2. Use

Installation

1. Test the transmission range (max. 60m in open field) prior to mounting the button. Plug in the receiver and

temporarily mount the button on the doorjamb. Press the button.

2. Mount the button with double-sided tape or screws if the test was satisfactory.

Changing the chime

You may wish to change the chime. Follow the instructions below.

Warning: Unplug the receiver from the mains before opening the

housing. Reseal the housing and replace the screw before you plug

the receiver in again.

1. Move the two jumpers (see 1 in figure) on the three terminals to

select one of the available chimes: dingdong or “Westminster”.

2. If another doorbell system on the same channel interferes with

the DB2’s operation, you should select a new channel for both the

doorbell button and the chime. You can do this by moving the

jumpers of both the doorbell button AND the receiver (see 2 in

figure). Always use the same configuration for the button and the

receiver.

3. Select one of the bell chimes: ding-dong or “Westminster”.

RED Declaration of Conformity

Hereby, Velleman NV declares that the radio equipment type DB2] is in compliance with Directive 2014/53/EU.

The full text of the EU declaration of conformity is available at the following internet address:

www.velleman.eu.

Use this device with original accessories only. Velleman nv cannot be held responsible in the event

of damage or injury resulted from (incorrect) use of this device. For more info concerning this

product and the latest version of this manual, please visit our website www.velleman.eu. The

information in this manual is subject to change without prior notice.

The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.

No part of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise

without the prior written consent of the copyright holder.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Velleman DB2 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info