Bedienungsanleitung Velodyne DD-18plus (Seite 36 von 42) (Englisch)

567711

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

e. If any dips are of higher concern than the rest of the peaks, then proceed to use Steps 14a through 14c for those, but pull

the EQ filter marker up in level.

f. Proceed cautiously with the dips, as you are very likely to find one or more that cause you to want to put multiple filters

ery near each other to get “enough boost”. This will be a null, which can show very little change after applying a lot of

acoustic power at its particular frequency. It is best not to EQ these very much.

5. Now you can modify the settings for the presets if you want. The most common settings to focus on for preset adjustment are the

preset contour frequency, contour level and the Theater/Music setting. However, if you want to change the crossover frequency,

crossover slope, phase and polarity for each preset, you should do so now following the procedure outlined in Steps 8 and

Steps 10 through 13.

16. If you are using the Windows Setup program, exit Manual-EQ by clicking Save and Exit. If you are using the TV screen interface,

select Exit/Save in the upper right of the screen and then select Yes to save.

17. Stop the Sweep Tone CD.

18. If you are using the Windows Setup Program, keep it open. If you are using the TV screen interface, push 1-2-3-4-5 on the remote

and then press Select quickly after.

19. If you are using the Windows Setup Program, wait for it to reconnect to the subwoofer. If you are using the TV screen interface,

the subwoofer is already connected to the TV.

20. Play the appropriate media through the Digital Drive

LUS

subwoofer for the preset you want to change. Proceed to modify contour

frequency, contour level and the Theater/Music settings.

a. For each preset, decide upon a frequency for the contour. Set the contour level to somewhere between 2.0 and 4.0 so

you can hear the change. Listen to your media and adjust the contour frequency until the contour is boosting the correct

frequencies to your taste.

b. Then adjust the contour level to your taste. These values are proportional to, but not equal to a dB.

c. While listening to the media, change the servo gain, or Theater/Music setting. A setting of 8 has the most gain and the

lowest distortion as noted previously, while 1 has the least gain. Even in the 1 setting, the Digital Drive

PLUS

subwoofers

have lower distortion than conventional subwoofers. Select the setting that yields the best appropriate accuracy for

your media.

21. At this point, you can adjust the subsonic filter and subsonic filter slope. Adjust them with preservation of dynamic headroom in

mind for dynamic media with little content below 20 Hz and maximum extension for media with extreme extension, but little

dynamic need. The factory default setting works well in most cases. If you are playing content that is particularly dynamic with little

sub-20 Hz content, it is wise to raise the frequency. Media with extremely low bass content but little dynamics may be better

reproduced with a lower slope.

22. Finally, adjust the volume for your new presets to match the appropriate satellites or lend the correct character to your playback.

23. Make sure you save your settings before leaving the Windows or TV screen interfaces or powering off the subwoofer using the

Save to DD+, Save, Save As…, or Save To File commands for the Windows program or Save/Exit and Yes for the TV screen

interface. If you don’t save your changes, they are lost when you exit Manual-EQ or the subwoofer turns of

[ 33 ]

igital Drive

LUS

ser’s Manual

RECOMMENDED PARAMETERS

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Velodyne DD-18plus Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Velodyne DD-18plus

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info