[Max Min Memory]
- Press to show maximum, minimum & current air, indoor & outdoor temperature readings
- Hold 3 seconds to clear the memory
[Alarm (Bell)]
- Press to show alarm time. When alarm time display, press to on/off alarm.
- When alarm time display, press and hold 3 seconds to enter setting alarm time
[Clock]
- Press and hold 3 seconds to enter setting clock
[Snooze]
- When alarming, press the button to enter snooze.
CLOCK SETTING
Hold “CL
OCK“ button for 3 seconds to enter clock set. Using “ + , - “ to adjust and “ CLOCK ” to
confirm, the following values can be set in sequence: Hr > Min > 12/ 24 >Existing Weather >
confirm & exit (if not confirmed, auto exit & save after 1 minutes)
ALARM SETTING
Press to view
Alarm Time for 10 seconds.
Hold “ALARM“ for 3 seconds, Hr will flash, press “ +, - “ to enter the desired value and press
“ALARM“ to confirm. Minute will flash, press “ +, - “ to enter the desired value and press
“ALARM“ to confirm. Alarm mode Zz will flash, press “ +, -“ to select Zz snooze alarm, (bell) daily
alarm or Alarm off (no icon). Zz snooze alarm will be enabled when user enter into alarm setting
each time.
SNOOZE
Press SNOO
ZE to trigger snooze alarm. To stop alarm for one day, press ALARM key but not
“SNOOZE” key.
Setting up the sensor:
1) Hold the [Channel/Search] button on the main unit W263 to search for the sensor
2) Select the channel number on the remote sensor by rotating to the desired channel number
3) Hold the [Tx] button inside the battery compartment of the plant sensor W235 to transmit
signal
4) Once RF synchronization is completed, the corresponding channel data will be displayed on
the main unit
To setup for another remote sensor, select different channel number on the sensor and follow
above procedure.
Soil moisture display:
Moisture Levels:
Wet 4 bars
Slightly Wet: 3 bars
Slightly Dry: 2 bars
Dry: 1 bar
WEATHER FORECAST
The unit predicts weather condition of the next 12 – 24 hours based on the change of atmospheric
pressure. The coverage area is around 30 – 50 km. The weather forecast is based on
atmospheric pressure change and is about 70-80% correct. As weather conditions cannot be
100% correctly forecasted, we cannot be responsible for any loss caused by an incorrect forecast.
