806422
47
Zoom out
Zoom in
Vorherige Seite
1/132
Nächste Seite
46
EN
6. Installation of the appliance
This appliance is not intended for use as a built-in refrigerator.
Use the front adjusting legs to level the appliance. If the appliance is not
level, it may affect the performance of the gasket seal or even lead to a
failure of your appliance.
It must be possible to disconnect the appliance from the mains power
supply. The plug must therefore be easily accessible after installation.
Place the appliance on a rm and at surface (oor) so that it is
stable, otherwise vibrations and noise may occur. When placing the
refrigerator on oor coverings such as carpets, straw mats or polyvinyl
chloride (PVC), place a solid sheet or cover under the refrigerator to
prevent colour change due to heat dissipation.
Before plugging in the power cable, check that the voltage and
frequency of the type plate match your power supply network. The
appliance must be earthed. The power cable is supplied with a contact
for this purpose. If the socket is not earthed, connect the appliance to a
separate earth according to current regulations and consult a qualied
electrician.
7. Mounting accessories: door compartments and shelves
To store food of different sizes, the door compartments can be set to
different heights. Proceed as follows: gradually pull the compartment in
the direction of the arrows until it comes loose and put it in the desired
position.
The walls of the refrigerator are equipped with a series of guide proles
so that the shelves can be inserted if desired. To remove the shelf, lift it
rst and then pull it out. To put the shelf back in place, push it into place
before lowering.
For the two-piece shelf, rst push back the rst part and then pull out the
second part.
Raise the rear edge of the shelf to prevent food coming into contact with
the wall lining. Hold the shelf rmly when removing or replacing it and
take care to avoid damage.
47

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Veripart VPSBSW177Z wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info