Bedienungsanleitung Vermeiren Carpo 3 (Seite 10 von 136) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

658530

Zoom out

Zoom in

Vorherige Seite

1/136

Nächste Seite

SCOOTER Instruction Manual

Last updated: 2017-02

CHANGING THE BATTERY

Risk of burns - Do not come in contact with the acid from the batteries. See for a good

ventilation of the battery compartment.

Replace both batteries at once and not one battery.

Cha

nge the batteries of your electric wheelchair, scooter with the same type batteries (Type: "AGM-

Absorbed glass mat" batteries).

The supplied battery charger works only with AGM batteries.

If you use other types of batteries, replace also the battery charger. Improper batteries, battery

chargers voids any warranty claim. Contact your specialist dealer about other batteries, battery

chargers in case of uncertainty.

The battery shall be changed by trained personel. To change the batteries, send your electric

wheelchair to the specialist dealer.

BATTERY STORAGE

If you no longer use your scooter, you could leave it connected to the battery charger. Charging is

automatically controlled by the battery charger. If you remove and store the batteries, kindly note the

following:

 Remove the cable clamps from the poles

of the battery.



The positive pole must at least be covered by a pole cap.

 Make sure that no objects can make contact with both poles during the time of storage (dan

ger of

hort circuits

!).



Batteries should only be stored in dry, well-ventilated spaces at a temperature between 5°C and

+40°C. +20°C).

 Protect the plugs and sockets against corrosion.

 Protect the batteries against deep discharging (see the chapter on battery charging).

If you have further questions, consult your specialist dealer who will gladly help you in regard to

storage and servicing of your batteries.

L If batteries are not used, they can discharge fully.

THERMAL SAFETY MECHANISM

To protect the motor against overload, your scooter comes with a thermal safety mechanism that will

automatically cut the motor to prevent overheating and thus rapid wear and tear or breakdowns. You

can access the thermal safety device through a gap in back of the synthetic cover. For those models

that have no synthetic cover, the thermal safety mechanism will be located on the battery boxes.

The thermal safety device can go loose if you go up or down slopes that exceed the maximum

gradient indicated. Nominal loads that exceed the maximum permitted could also cause the device to

jump out. Likewise, if you keep on driving with the engine brake on, it could result in overload. The

maximum values not to exceed are indicated in the chapter on “Technical Details” of the

corresponding manual.

To be able to use the scooter again, remove the overload and wait till the motor has cooled off. Then

gently press the thermal safety mechanism back in. Your scooter is now ready for use again.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Vermeiren Carpo 3 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info