Bedienungsanleitung Vermeiren Controleunit DX2 Basic (Seite 3 von 20) (Englisch)

514914

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

DX2 Operator control

vD - 2013-04

1.1. DX2 without LCD screen

Press the "ON/OFF" button (1). The charge indicator (2), which also indicates the batteries' charge

level, lights up for a moment. If all the lights come on, the batteries are sufficiently charged. If the lights

do not all come on, you must adjust your driving activities to suit the low capacity of the batteries. If the

battery charger display lights do not come on, check the plug connections of the electronic system.

Now select the driving program you want by pressing the speed switch (3), (-) symbol to go slower and

(+) symbol to go faster.

The selected speed is showed with the speed indicator (4). If you have any special needs, you can

ask your dealer to enter a personalised driving program.

To set the wheelchair in motion, push the joystick forwards slowly. The speed will increase when you

push the joystick further forwards. If you want to turn left or right, simply push the joystick in the

desired direction. To reverse, pull the joystick backwards from the central position.

Note that, when pressing the "ON/OFF" button, the joystick stays in the central position for at

least two seconds. It is programmed this way for technical and safety reasons, to prevent the

joystick being pushed at the same time as the wheelchair is being switched on. If both

processes are activated at the same time, the steering unit locks itself and can only become

operational again after being switched off completely.

Press the “Left indicator” (10) or “Right indicator” (11) buttons to signal a change in your driving

direction. The driving lights are switched on or off by pressing the “Lights” (15) button. You can sound

an acoustic warning signal with the “Horn” (5) button. The hazard warning lights, used in critical

situations, can be switched on or off by pressing the “Hazard warning lights” (14) button.

To brake while driving, simply push the joystick to its central position. Move the joystick slowly for

gradual braking. Simply release the lever for a quick stop; the wheelchair will then stop as quickly as

possible.

To activate the back adjuster, select button (13) until the corresponding number for the backrest

adjustment actuator lights up, and you can then use the joystick to tilt the back in the direction you

want.

To activate the seat incliner, select button (13) until the corresponding number for the seat adjustment

actuator lights up, and you can then use the joystick to incline the seat in the direction you want.

Turn wheelchair On/Off

In case of an emergency, you can use the On/off button to turn your wheelchair off.

Turn the power on:

Press the On/Off button. All LEDs of the battery indicator turn on simultaneously

and the fault indicator flash twice.

If the wheelchair is turned on while the joystick is out of neutral, an fault will be displayed on the

battery charge indicator (the five drive profile LEDs flash continuously and the chair will not drive).

Release the joystick back to neutral and the fault will disappear. If the joystick is not released

back to neutral (centre) within 4 seconds, the fault becomes a Module fault (the drive profile LEDs

+ fault indicator are flashing). To clear this fault, turn the DX system off and then turn it back on.

Turn the power off:

Press the On/Off button. All LED's will goe out. If the ON/OFF button is pressed

while driving the wheelchair perform an emergency stop and it turns off.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Vermeiren Controleunit DX2 Basic Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Vermeiren Controleunit DX2 Basic

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info