Bedienungsanleitung Vermeiren Forest kids (Seite 22 von 32) (Englisch)

797978

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Forest kids

2015-11

Page 20

no longer provide power for driving. The batteries should therefore be charged before these

error messages appear, using the supplied battery charger IMPULSE S (8 A). Avoid the

batteries becoming drained, in any case.

 FIRST USE

First put the plug into the wall socket. After an LED combination has lit up, the charger

switches to STANDBY. Both LEDs (green and yellow) are active.

Next, connect the charger cable with the three-pin plug to the loader socket on the electric

wheelchair's operator control. Once connected to the batteries, the charger automatically

begins charging. Now only the yellow LED is active.

When charging is complete, the yellow LED goes out and the green LED comes on. Now

remove the charger cable from the operator control. The charger switches back to STAND-

BY mode (yellow and green LEDs active).

If the charger cable is not removed, a tiny current will keep the batteries topped up (trickle

charging).

If you decide not to use your electric wheelchair for an appreciable period, you must

nevertheless recharge it regularly to keep it in a running condition ready for immediate use.

The manufacturer accepts no liability for damage caused by improper charging.

For further information, please refer to the user instructions provided with the charger.

2.23 Use of the wheelchair as seat in a motor vehicle

L WARNING: The wheelchair has passed the crash of ISO 7176-19: 2008 and, as

such, has been designed and tested for use only as forward-facing seat in a

motor vehicle.

L WARNING: The wheelchair's pelvic belt alone is not suited as an occupant

restraint belt.

The wheelchair is tested using the four-point strap-tie system and a 3-point occupant-

restraint system.

Whenever feasable, use the seat of the vehicle and store the wheelchair in the cargo area.

Steps to secure the wheelchair in a motor vehicle:

1. Check that the vehicle is equipped with a suitable wheelchair tie down and occupant-

restraint system, conform ISO 10542.

2. Check that the components of the wheelchair tie down and occupant restraint system

are not frayed, contaminated, damaged or broken.

3. If equipped with an adjustable seat and/or back tilt, make sure that the wheelchair

user is sitting as upright as possible. If the user's condition prevents this, a risk

assessment should be done to evaluate the user's safety during transit.

4. Remove all mounted accessories such as trays and respiratory equipment, and

secure them in a safe place.

5. Position the wheelchair facing forward in the travelling direction, centrally between the

tie-down rails mounted in the floor of the vehicle.

6. Make sure that the indicated zones around the wheelchair user are clear from rigid

vehicle parts.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Vermeiren Forest kids Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Vermeiren Forest kids

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info