TRANSPORTING THE SCOOTER
If your scooter is to be transported, please note the following:
Before picking up the scooter all movable parts must be removed (basket, armrests, etc.). You could
also remove the batteries / battery boxes from the seat to save weight.
As gel batteries are closed battery systems, removal for the purpose of transportation will cause no
problem.
When raising the scooter, it should be held by fixed parts of the frame only.
To prevent damage, all loose parts should be removed prior to transportation.
When assembling, make sure that all screws are retightened properly.
To prevent personal injury or damage to the scooter, there should be no people or objects
under the scooter during transportation.
Likewise, there must be no people or objects on the foot rests or seat during transportation.
USING RAMPS
Should you wish to use ramps to drive over an obstacle, please note the following:
For your own safety, find out from the manufacturer what the maximum load is that the ramps can
bear. Drive on the ramps at the lowest speed possible. Also see the instructions in chapter “Your first
trip with the scooter”.
If another person is pushing you, note that the considerable weight of the electric scooter generates
large reverse forces.
Observe the instructions on the maximum load of the ramps used.
We shall decline all liability for injury or damage caused by an improper choice of ramps.
SERVICING
Like all other technical products, your electric scooter will require servicing. Below follows a list of
actions to be taken to ensure that you keep on enjoying the benefits of your scooter, even long after
you purchased it.
z BEFORE DRIVING
Check the tyres for visible damage and/or soiling. Remove any dirt as it could impair the road-
holding capacity of the tyres. When a tyre is damaged, please go see an authorized workshop
for repair.
Before driving, check the motor brake. If it does not function properly, please consult your
specialist dealer.
Check the tyre pressure and inflate them if necessary.
Make sure that all screws are tightened properly.
Switch on the electronics after verifying that the motor is engaged. The load indicator indicates
the level of the batteries. If the battery charge is sufficient for the intended route, you can set
out.
zAPPROX. EVERY 8 WEEKS
Depending on the frequency of use, check the following:
1. Dirt under the rear chassis (carefully remove any dirt as it can corrode the plugs).
2. Dirt / corrosion on the poles of the batteries (be careful to keep the poles of the batteries
clean as dirt may damage the batteries).
Remove the pole connectors before cleaning the poles of the batteries.
