Bedienungsanleitung Vermeiren Mercurius 4D - 2021 (Seite 19 von 184) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

797877

Zoom out

Zoom in

Vorherige Seite

1/184

Nächste Seite

Mercurius 4D

2021-02

Using your scooter

Risk of damage

 Battery self-discharge and the quiescent current of the connected users will drain the

battery

charge slowly. The battery may be irreversibly damaged if the battery is fully discharged.

Therefore, make sure that the battery is charged on time:

o With intensive use (long distances, daily use): Immediately recharge after use.

o With

average use (short distances, daily or a few times a week): Charge when battery

indicator shows 50% discharge.

o With little use or storage: Charge once a week.

 Read the storage and maintenance instructions in chapter 4 and technical

details in chapter 6.

 Only disconnect the battery charger when the battery is fully charged, see

the following symbols on the charger.

 Do not charge batteries below 0°C. Move the battery to a warmer place

and start charging.

 Keep the connection point for the battery charger free of dust and other contamination.



In case of any problems whereby the battery cannot be charged according to following

instructions, please contact your specialist dealer.



For instructions

on how to change the batteries, see the installation manual.



It is recommended to unplug the battery charger from the mains when not in use. This is

to prevent unnecessary energy consumption.

 If appliances stay plugged into the USB port

while charging the electronic wheelchair, the

battery will never charge fully. Therefore, unplug all appliances from the USB port before

charging the wheelchair.

The light emitting diode (LEDs) in the steering unit indicates the remaining capacity of your

batteries. If the battery charger is turned on and no LED's are lit, check the fuse. If the red LED

does not illuminate, the charger is defective.Consult your specialist dealer.

1. Switch the scooter OFF and remove the key.

2. FIRST connect the battery charger to a 230V AC power socket.

3. Refer to the battery charger manual for the explication of the indicators on the charger.

4. If applicable, open the cover of the charging point on the scooter.

5. Connect the charger.

6. Refer to the battery-charger manual for the explication of the indicators on the charger.

7. When the battery is fully loaded, disconnect the scooter from the charger.

8. Switch the scooter ON and check if all lights of the battery status indicator are ON.

9. Remove the charger from the socket, let it cool down and store it in a dry location.

When the operating console displays the warning

code “Drive inhibit” after charging, make

sure that the battery charger is disconnected. This safety measure prevents driving with the

charger still connected to the supply grid.

CAUTION

1 = Key

2 = USB connection

3 = Socket battery charger

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Vermeiren Mercurius 4D - 2021 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info