Bedienungsanleitung Vermeiren Springer (Seite 22 von 32) (Englisch)

797981

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Springer

2014-10

Page 20

To prevent damage on the wheelchair:

 Put the electrical adjustments in standard position (lift column as low as possible,

seat inclination horizontal, back inclination the most foreward).

 Fold the footplates upwards, place the armsupports in the most inward position.

 Check that the adjustment levers are positioned inwards.

 Cover the operator control with an soft material that can withstand shocks.

Before travelling contact the concern airline about there requirements for transporting

the wheelchair in an airplane.

2.18 Batteries

The standard for your electric wheelchair is two closed, 12 V/38 Ah AGM batteries. The

batteries used with your electric wheelchair are drive batteries which only attain full capacity

after a few charging and use cycles.

If the batteries lose their power after long usage, or if they are damaged, get them both

replaced by a specialist dealer only.

We accept no liability for damage caused through using other types of batteries.

If the batteries are opened, all manufacturer liability and all claims will become void.

Do not use the batteries at temperatures below +5°C or above +50°C (the ideal is: +20°C).

2.19 Battery charger

To charge the batteries, only use the battery charger supplied - IMPULSE S (6 A).

For the user instructions of the battery charger you can refer to the manual of the Impulse S

that is delivered with your battery charger.

2.20 Charging the batteries

L CAUTION: Risk of injury - Only use the battery charger supplied to charge

batteries.

As the IMPULSE S (6 A) charger aligns the charge curve with the AGM batteries' charge

level, you can recharge your wheelchair after each use. This avoids any aggressive battery

charging and the "memory effect".

Recharge the wheelchair, at the latest, when the charge indicator on the steering unit goes

into the red zone. If, despite this, you continue driving, eventually only the last red diode

lights up and flashes continually, indicating that the batteries are nearly flat. If you disregard

this warning signal, too, an error message will shortly appear indicating that the batteries can

no longer provide power for driving. The batteries should therefore be charged before these

error messages appear, using the supplied battery charger IMPULSE S (6 A). Avoid the

batteries becoming drained, in any case.

 FIRST USE

First put the plug into the wall socket. After an LED combination has lit up, the charger

switches to STANDBY. Both LEDs (green and yellow) are active.

Next, connect the charger cable with the three-pin plug to the loader socket on the electric

wheelchair's operator control. Once connected to the batteries, the charger automatically

begins charging. Now only the yellow LED is active.

When charging is complete, the yellow LED goes out and the green LED comes on. Now

remove the charger cable from the operator control. The charger switches back to STAND-

BY mode (yellow and green LEDs active).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Vermeiren Springer Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Vermeiren Springer

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info