Bedienungsanleitung Vermont Castings Gifford (Seite 11 von 30) (Englisch)

815506

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

11 04/237102-803E

Figure 11.1

Start-up Air Control

To activate: Push back until it stops

3. Final Stage - Thenalstageofburningisthecharcoal

stage. This occurs when the ammable gases have

been mostly burned and only charcoal remains. This is

a naturally clean portion of the burn. The coals burn with

hotblueames.

It is very important to reload your appliance while

enough lively hot coals remain in order to provide the

amount of heat needed to dry and rekindle the next load

ofwood.ItisbesttoactivatetheACCbeforereloading

(Figure 11.1). This livens up the coal bed and reduces

excessiveemissions(opacity/smoke).Opendoorslowly

so that ash or smoke does not exit appliance through

opening. You should also break up any large chunks and

distribute the coals so that the new wood is laid on hot

coals.

Air quality is important to all of us, and if we choose to use

wood to heat our homes we should do so responsibly.

To do this we need to learn to burn our appliances in

the cleanest way possible. Doing this will allow us to

continue using our wood appliances for many years to

come.

G. Start-Up Air Control

Whenusingthestart-upaircontrolsystem,youdonothave

to continually monitor the re. Once you set the start-up

aircontrolsystemitwillcontrolthereforyou.Followthe

instructions below to learn how to operate your appliance

with ease.

H. Burn Rate and Operating E󰀩ciency

For maximum operating e󰀩ciency

• Burndry,well-seasonedwood.

• Follow these burn rate instructions below.

Burn Rate

1. Starting a Fire:

- Load appliance with wood and start re (reference

Quick Start Guide on page 6).

- ActivateACC.

2. Reloading:

- Addwoodasneeded.

- ActivateACC.

3. Adjusting the Burn Rate - This wood appliance is

designedtooptimizee󰀩ciencyatalltimes.Sincethere

are no user controls to adjust the burn rate, the easiest

method is to learn how many logs you need at a time for

theamountofheatdesired.Inadditiontotheamountof

wood and the size of the logs, take the time to experiment

with split and unsplit logs as split logs will burn faster

than unsplit logs.

NOTE:Ifusingtheblower,itshouldbeo󰀨fortherst30

minutes and then be operated in the desired setting at 30

minutes.

This wood appliance has a manufacturer-

set minimum low burn rate that must not be

altered.Itisagainstfederalregulationstoalter

this setting or otherwise operate this pellet

insert in a manner inconsistent with operating

instructions in this manual.

WARNING

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Vermont Castings Gifford Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Vermont Castings Gifford

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info