Bedienungsanleitung Vibiemme Domobar Super (Seite 31 von 44) (Englisch)

783524

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

CAUTION: The cleaning products meant for backﬂushing must NEVER be used in the water reser-

voir. Using this cleaning agent in any way other than described here can damage your machine and void

your warranty.

Cleaning the Portaﬁlter and Filter Basket - Pop the ﬁlter basket out of the portaﬁlter body. Using a ﬁnger-

nail is not recommended as these commercial portaﬁlters have a very stiff retaining spring inside. Using the back

edge of an old butter knife as a lever between the portaﬁlter body and basket edge works quite well.

Dissolve a bit of espresso machine cleaner in hot water in a glass container. The solution can also be used to

clean the portaﬁlter body as well as the portaﬁlter baskets and any other similar parts soiled with coffee. These

parts can be disassembled and soaked overnight if necessary to remove stubborn stains, but soaking them for ﬁve

to ten minutes is usually more than sufﬁcient for properly maintained parts.

As Necessary

Exterior Cleaning

NEVER use any abrasive cleaners or cleaning pads on your Domobar Super. They WILL scratch the surface.

A quality glass cleaner sprayed on a rag will usually do a good job of cleaning the outer surfaces, but do not spray

these in the area of the grouphead, and always wait for the machine to cool before cleaning the exterior. For more

difﬁcult stains try alcohol on a microﬁber rag, or really tough stains can be removed with a little Urnex Clearly

Coffee. If your machine has painted panels take care to use products that are compatible with powder coating. No

solvents should ever be used as these may permanently damage the powder coating’s sheen.

Grouphead Gasket Replacement

The thick, rubber gasket that seals the portaﬁlter in the grouphead is subjected to a lot of heat and pressure.

Over time it will harden and the portaﬁlter’s action will create a depression in the surface. If it begins to leak, the

ﬁrst resolution is to give it a good cleaning as mentioned above. If that does not cure the problem then replace-

ment is the next step. Before attempting this it is a good idea to have the spare gasket as well as a spare shower

screen on hand.

The most difﬁcult thing about replacing the grouphead gasket is removing the old one. Depending on just

how hard or old the existing gasket is will dictate the difﬁculty of removing it. First try removing it by gently

prying it out. Use a small screwdriver or a paint can opener. Take care not to damage the chrome surface of the

grouphead.

If that does not seem to be working, the next step is to use one or two drywall screws. Try using a single one

at ﬁrst and screw it directly into the black, rubber gasket, then grasp it with a pair of pliers and pull it out (be care-

ful not to scrape your knuckles if the screw suddenly pulls out). Placing another, 180 degrees from the ﬁrst will

allow pulling on one side then the other to work it out of the grouphead. If the screw just pulls out of the rubber,

use a larger-diameter wood screw, ﬁle off the pointed tip so it if ﬂat, and screw it into the gasket in the same hole

made by the drywall screw until it touches the grouphead, and then continue turning the screw. As it penetrates

the gasket and hits the grouphead it will pull the gasket down the screw. If this isn’t working, try repeating the

process with a second wood screw in the other hole.

If you do this and the gasket breaks that is ﬁne. You can then just pry it out with a small screwdriver or ice

pick. Use care not to mar the grouphead. It is a very good idea to have a spare shower screen on hand when at-

tempting this job. The screen is held in place by the gasket, and if you have to go at the gasket with vigor the

shower screen can be damaged. Having a spare on hand will limit downtime.

Once the gasket is out, remove the shower screen and give the area a good cleaning. Be sure that no old

gasket or coffee residue is left in the grouphead. If need be, use a brass-bristle brush to clean the area.

To install the new gasket, assemble the gasket over the shower screen and place them on a portaﬁlter, Maneu-

ver the assembly into place and then simply lock the portaﬁlter into place as you would when making espresso.

The cam-action of the portaﬁlter locking into place will push the shower screen and gasket into place.

How often this needs to be done depends on many factors, but for in home use about once every six months

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Vibiemme Domobar Super Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info