Bedienungsanleitung Vicks V790 (Seite 5 von 31) (Englisch, Französisch, Spanisch)

650705

Zoom out

Zoom in

Vorherige Seite

1/31

Nächste Seite

longer than 2,000 hours but at a reduced output. To keep your humidiﬁer operating

at maximum efﬁciency it is recommended that the UV bulb be replaced after

2,000 hours of use.

REFILL INDICATOR - When illuminated, the water tanks need reﬁlling. See the

section “Filling the Water Tanks”. If still illuminated a few minutes after full tank

is placed on base, reposition water tanks. (Unit will operate with only one water

tank.) Each time you ﬁll tanks, rinse tanks, hot water reservoir and cold water

reservoirs. Clean them according to CLEANING INSTRUCTIONS if minerals or

ﬁlm are present.

RELATIVE HUMIDITY CONTROL - This controls the humidity level. If moderate

humidity is desired, the control should be turned counterclockwise toward “ ”;

and if higher humidity is desired, clockwise toward “ ”. NOTE: When you

unpack your humidiﬁer, you may ﬁnd it has droplets of water on some surfaces.

This is normal as every unit is tested prior to shipping. Carefully unpack humidiﬁer

and remove all packing material.

OPERATING INSTRUCTIONS

1. Place the base of the unit on a ﬁrm, ﬂat, level and water resistant surface.

2. Fill the water tanks according to the instructions below and place on

humidiﬁer base.

3. Plug the power cord ﬁrmly and completely into the wall outlet.

4. Push the power switch to the ON position (Lights may ﬂicker momentarily).

Then turn the relative humidity knob clockwise until you hear a faint click. It will

be normal for the humidiﬁer to take a few minutes to warm up and begin to mist.

5. When the water tanks are empty, (after approximately 24 hours running time),

the “REFILL WHEN LIT” lamp will go on, and the unit will stop heating. Refer

to the “FILLING THE WATER TANKS” section.

6. Whenever the water falls below the level of the ﬂoat switch during operation,

the heating element will shut off and stop heating, and the REFILL indicator

will light.

7. The unit will operate as long as there is water in either tank and unit will

operate with either one or both tanks.

FILLING THE WATER TANKS

1. Before ﬁlling the water tanks, push the POWER switch to the “OFF” position

and unplug unit. Refer to CLEANING INSTRUCTIONS.

2. Remove water tanks from base, turn each tank upside down and remove tank

cap by turning counterclockwise. Fill tank with clean cold tap water. Replace

the tank cap by turning clockwise. Tighten ﬁrmly.

3. Carefully pick up tank, since it will be heavy when full, and slippery if wet.

4. Place water tanks on base. Make sure tanks are properly placed, otherwise,

the humidiﬁer will not work correctly.

USING THE MEDICINE CUP

In order to add Vicks VapoSteam or Kaz Inhalant to the “mist” output:

1. Push the POWER switch to the “OFF” position and allow the Top Housing to cool.

2. Carefully add liquid medicine to medicine cup. DO NOT ﬁll the cup more than

half full.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Vicks V790 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info