Bedienungsanleitung Victron Phoenix acculader 12 30 (Seite 4 von 96) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch)

785489

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

victron energy

DESCRIPTION

Technology

The Phoenix Charger is a fully high-frequency

switched battery charger. The input is

electronically powerfactor corrected by the first

powerstage.

The next stage gives provision for galvanic

isolation and a perfect DC voltage at the output

terminals.

A very accurate charging state of the battery is

guaranteed because the charging process is

microcontroller regulated.

The internal electronic parts are protected against

moisture and dirt by means of a special coating,

which assures a long lifetime of your battery

charger.

Two high-capacity batteries and an additional low-

capacity battery can be charged with this charger.

Adaptive Charging

The new Phoenix Charger uses the Adaptive

Charging Characteristic. The Adaptive Charging

Characteristic distinguishes from other charging

characteristic on several topics. The main 3 topics

are Rapid Charging, Battery Safe Mode and All

Season Mode.

Generally speaking the Phoenix Charger will

adapt to the connected batteries.

Rapid charging

In the first stage, the bulk phase, of the charging

cycle the batteries are charged with higher current

then traditional charging methods. The bulk phase

will stop at the point where the battery voltage will

be 14,4V or 28,8V. From here the absorption

phase will start.

Based on the measured bulk time the length of the

absorption time will be calculated. For this the

charger micro-controller will monitor several

parameters of the battery.

BatterySafe mode

But what if your battery needs a higher absorption

voltage? The charger will gradually raise the

applied voltage to the battery until it reaches the

set absorption voltage. This phase we call the

BatterySafe Mode. It will safe your battery from

destruction by overcharging.

The Phoenix Charger is temperature

compensated. The charger will recalculate

different values based on the battery temperature.

All Season mode

For periods were you do not use your batteries

and the mains is applied to the charger, the

Phoenix Charger will reduce its float voltage. By

doing this we reduce the gassing in your battery

so they will not run dry after a longer period of not

using your battery.

To keep your batteries in shape the Phoenix

Charger will raise the applied voltage once a

week. This we call the repetitive absorption.

Operation

The battery charger charges the battery with a 4-

stage adaptive charging characteristic, see

specifications at the back for details. It can remain

connected to the battery continuously, without

increased gas formation, caused by overcharging,

taking place.

The charger can be used for different types of

batteries but the default settings are for

Sonnenschein A200 dryfit gel batteries. See

specifications for other pre-programmed battery

types.

For use with other types of batteries please

contact your battery supplier to inform you about

the right charging voltages. If necessary let the

Phoenix Charger be readjusted.

The full charging current of the Phoenix Charger is

divided in two main outputs.

An extra output with limited charge capacity is

available to charge a starter battery for example.

The charger is protected against short-circuit at

the outputs and too high ambient temperature.

Temperature sensor

The Phoenix Charger is factory shipped with a

temperature sensor. Its function is to measure the

battery temperature and adjust the charging

voltages accordingly. By this means superiour

charging is achieved and a longer lifetime of the

battery is assured.

Voltage sense

Using the Voltage sense connection will

compensate the battery cable loss.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Victron Phoenix acculader 12 30 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info