785492
16
Zoom out
Zoom in
Vorherige Seite
1/32
Nächste Seite
14 Manual Skylla with universal input
3.2 Operation
Located on the front of the Skylla charger are an on/off switch and three rows of
leds, as shown in illustration 5.
The battery charger can be switched on and off with the on/off switch.
The “output voltage” leds indicate the output voltage value.
The “output current” leds indicate the output current value.
The other leds indicates the state of the charger.
The operation sequence:
Switching the charger on with the on/off switch results in the following:
The “on” led will flash for about 2 seconds. In these first 2 seconds the charger
reads all input signals and calculates the necessary output voltage. After 2
seconds the charger will switch on and the “on” led illuminates.
According to the condition of the battery the charger will start in the boost-
charge mode or at float-charge mode. If the battery is not full the “boost” led
illuminates and the charger will start boost-charging the battery.
A dip switch can be used to set the charger so that it will always start charging
in the boost mode, irrespective of the condition of the battery.
When the battery voltage has reached the boost voltage the charger will change
into the equalize-charge mode and the “equalize” led illuminates. This mode will
last for a pre-selectable time of 4, 8 or 12 hours.
After this time the charger will enter the float-charge mode and the “float” led will
illuminate.
After the batteries are charged the Skylla charger does not have to be switched off
and the batteries can stay connected to the battery charger.
Illustration 5. Example of the battery charger front panel.
victron energie
ACCULADER
AUTOMATIL-LADER
BATTERY CHARGER
CHARGEUR AUTOMATIQUE
Output
voltage (V)
Output
current (A)
30
29
28
27
26
25
24
23
112
100
84
70
56
42
28
14
on
boost
equalize
float
failure
on
off
Explosive gasses can occur during charging a lead-acid
battery. Prevent flames and sparks.
Provide adequate ventilation during charging.
16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Victron Skylla-TG 24 30 (1 1) wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info