Bedienungsanleitung Viessmann Vitocal 151-A (Seite 16 von 76) (Englisch)

813835

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

Your heating contractor must carry out the commis-

sioning and matching of the control unit to local and

structural conditions and must also provide training in

how to operate the system.

Note

These operating instructions also describe functions

that are only available on some heating system config-

urations or only with accessories. These functions are

not specifically identified.

For questions relating to the scope of and accessories

for your heat pump and your heating system, contact

your contractor.

Your system is preset at the factory

Your heat pump is preset at the factory and is therefore

ready for operation:

Room heating/room cooling

■From 06:00 to 22:00, your home will be heated to

20 °C "Room set temperature" (standard room

temperature).

■If a separate buffer cylinder is installed, this buffer

cylinder will be heated.

DHW heating

■DHW is heated to "Set DHW temperature" 50 °C

every day from 05:30 to 22:00.

■A DHW circulation pump, if fitted, is similarly

switched on every day from 05:30 to 22:00.

■If required, the instantaneous heating water heater

built into the indoor unit can be switched to DHW

heating.

Frost protection

■Frost protection is ensured for your heat pump, DHW

cylinder and any separate buffer cylinder that may be

installed.

Note

At outside temperatures below –20 °C and in the

case of a fault in the heat pump, only the instantane-

ous heating water heater built into the indoor unit is

switched on to provide frost protection for the sys-

tem.

Wintertime/summertime changeover

■This changeover is automatic.

Date and time

■The date and time were set by your contractor.

You can change the settings at any time to suit your

individual requirements.

Power failure

All settings are retained if there is a power failure.

Energy saving tips

Saving energy when using room heating

■Do not overheat your home. Every degree of room

temperature reduction saves up to 6 % on your heat-

ing bills.

Do not set your standard room temperature ("Room

set temperature") to above 20 °C: See page 28.

■Heat your home to the reduced room temperature at

night or during regular absences (not applicable to

underfloor heating). For this, adjust the settings in

the time program for room heating ("Time pro-

gram"): See page 29.

■Adjust the heating curves so that your home is

heated with your individual preferred temperature all

year round: See page 29.

■To switch off functions that are not required (e.g.

room heating in summer), set the operating program

to "Standby mode" for the relevant heating circuits:

See page 28.

■If you are going away, set the "Holiday program":

See page 32.

During the period that you are away, the room tem-

perature will be reduced and DHW heating switched

off.

Introductory information

Commissioning

6199692

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Viessmann Vitocal 151-A Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Viessmann Vitocal 151-A

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info